WALL INLET INSTALLATION
MODEL 360 WALL INLET(361 Rough in)
1.Once the walls have been finished, install the wall inlets.
2.Remove the cardboard plaster guard.
3.Refer to Figure 13. For some dry wall or panel construction, the plaster frame will extend beyond the finished wall. In this case, remove plaster frame from mounting bracket by removing mounting screws.
4.Refer to Figure 14. Connect
5.Guide excess wire back through hole in inlet bracket and make sure seal is secure between mounting bracket and flanged fitting.
6.Refer to Figure 15. Place inlet into mounting bracket and secure.
NOTE: When wall inlets are installed in 1/2" thick walls or less, the tube of the wall inlet may extend into elbow area of the flanged fitting and cause blockage. Shorten the wall inlet tube to prevent this condition. See Figure 16.
For extra thick walls, use Model 399 extension sleeves to connect inlet to the flanged fitting.
FIGURE 13
FIGURE 14 |
MODEL 330 WALL INLET (329 Rough in)
See Figure 17.
1.Connect
2.Align inlet mounting holes with holes in mounting plate.
3.Place inlet into mounting plate and secure with two provided screws.
6
FIGURE 15
MODEL 365
DOUBLE FLANGED
TEE
WALL
INLET
WALL SHORTEN MOUNTING
BRACKET
FIGURE 16
INLET
MOUNTING
PLATE
FIGURE 17