If the right LED lights orange, either solid or blinking, see Troubleshooting 2 below.
DO NOT press Enter on the meter yet.
For wireless connection and meter setup go to Step 9 on page 7.
Troubleshooting 2
If the meter does not display the message, “ Meter connected to Internet”, your meter is not communicating with the Internet.
Try the following:
Also, the right LED changes from blinking orange to blinking green only.
LEDs
Confirm Connection
About 10 seconds after the meter completes its startup routine,
it displays the message:
Meter connected to internet-Press Enter
Installation Part 1 - Set Up Communication Device
8
•Check that the USB Cable (
) is connected properly.
•If the right LED is solid orange (not blinking), then the network cable is connected to an inactive port. Try other ports (for 10 seconds each) until you find one that is active (LED changes from solid orange to green).
•Restart the Communication Device by pulling the power connector ( 
) out, then reconnecting the power.
•If, after 60 seconds the message, “Meter connected to internet” is not displayed, consult your IT specialist.
Your IT specialist can refer to online troubleshooting assistance at: www.pb.com/support/LAN
5
