INSTALLATION (Continued)
MOUNTING AND CONNECTING
OPTIONAL DOOR RELEASE PUSHBUTTON
You have previously prepared the master station for the optional release pushbutton.
1.Refer to Figure 24. Feed one wire from the door release transformer and one wire from the door release mechanism through the pushbutton hole in the master station panel.
FIGURE 24 |
2.Connect the two (2) wires to the PB1WHCL pushbutton.
3.Rotate the pushbutton so the screws are on the top and bottom as illustrated, then snap the button into the mounting hole.
CONNECTING THE MEMORY
BACK UP BATTERY
Refer to Figure 25. Connect the
2 PIN PLUG
2 PIN CONNECTOR
FIGURE 25
PLEASE NOTE
If permanent AC power has not been connected, or the AC power will be off for long periods of time, the battery should not be connected at this time. When the battery is connected, the correct time and programmed radio memory stations will be retained for approximately 30 hours on battery backup.
SECURING THE MASTER PANEL
1.Refer to Figure 26. Inspect all wiring connections to make sure they are complete and correct.
2.Make sure all antenna connections are secure.
3.Dress all remote station wires flat against the terminal board.
▲ | CAUTION | ▲ |
|
|
WHEN RAISING THE MASTER PANEL TO ITS FINAL POSITION, DO IT SLOWLY! BE CAREFUL NOT TO HIT OR DAMAGE ANY OF THE CIRCUIT BOARDS OR CABLES.
FIGURE 26 |
4.Position the master station panel over the
5.Secure the master station panel to the
NOTE: The mounting screws will pierce the wall surface behind the mounting brackets. If the wall surface is hard, a clearance hole must be drilled behind the mounting bracket before securing the master station panel.
POWERING UP THE SYSTEM
Once all connections have been completed throughout the system, it is time to apply power to the master station.
1.Apply power to the master station by turning on the circuit breaker that supplies power to the transformers in the
2.When power is first applied, the LCD display will flash 1:00 PM. Refer to the Operational Checkout section of this manual for additional information.
11