NuTone IM-440 Series Contents Of Carton, Precautions And Guidelines, Wiring Specifications

INSTALLATION

CONTENTS OF CARTON

Check (✓) for the following IM-4406 carton contents.

❏IM-4406 master station

❏Terminal board

❏Transformer cover

❏Hardware bag assembly containing:

2 - shoulder screws

12 - No. 6 x 3/8 screws

4 - colored panel mounting screws

4 - ‘L’ panel mounting brackets

❏Homeowner’s manual with room labels

❏Installation instructions

❏Product Registration Warranty Card

NOTE TO INSTALLER: Do not discard these installation instructions. Please transfer all installation instructions, warranty registration and homeowner’s manual to the homeowner.

PRECAUTIONS AND GUIDELINES

The NuTone IM-4406 master station has been designed for ease of installation. Please read and follow ALL installation instructions, guidelines and precautions. Any deviation from these instructions or miswiring combinations may result in unit failure and void of warranty.

WARNING!

120 Volt AC Power to Transformers in the IR-105 Rough-in MUST Remain OFF until ALL System Wiring at the Master and Remote Stations is Complete.

•Observe all local building regulatory codes in your area.

•All screw terminals at the master and remote stations must be secure.

•Observe all color code connections of wires when connecting the remote stations to the master.

•The IM-4406 is designed to be installed with only NuTone specified wire. No other wire should be used. The use of wire other than NuTone wire will void all NuTone warranties and may result in faulty installation and improper operation.

IMPORTANT WARNING!

THE POWER TRANSFORMER CONTAINS AN INTERNAL FUSE.

DO NOT SHORT THE LOW VOLTAGE CONNECTING SCREWS OF THE TRANSFORMER OR THE TRANSFORMER WILL BE DESTROYED!

WIRING SPECIFICATIONS

See the IR-105 master rough-in frame installation instructions for detailed wiring information.

Use NuTone IW-6, 3 twisted pair for connecting:

•Remote controls to master

•Remote stations to master

Use NuTone IW-2, 22 ga. twisted pair for connecting:

•Door speakers to master

•Remote controls to speakers

•Speaker volume control (IC901) to master

•Speaker volume control (IC901) to speakers

•Electronic chime audio output to master

•Pushbutton to chime module

Use NuTone S-143, 18 ga. twisted pair for connecting:

•Pushbutton to electronic chime

•Electronic chime to chime transformer

Use Nº14/2 power cable with ground, Class 1 UL Listed (Observe local codes) for connecting:

• Transformers to 120v AC

Use shielded audio cable for connecting external audio sources to the master station.

REMOTE STATION WIRING

An individual 6-wire cable (IW-6) must be connected from each remote station or remote control location to the master station’s terminal board.

Maximum station wire length: 750 ft.

Maximum total length of IW-6 cable per system: 4,000 ft.

IMPORTANT! NuTone cannot be responsible for improper system operation that results from interference generated by light dimmers, fluorescent lighting fixtures, and similar electrical products. Such interference must be corrected at the source. TO HELP REDUCE THIS INTERFERENCE, ALL WIRING CONNECTIONS TO THE MASTER MUST BE PLACED AT LEAST 12 INCHES FROM ANY AC POWER WIRING. AVOID RUNNING INTERCOM WIRES PARALLEL TO AC POWER WIRING.

MAXIMUM NUMBER OF REMOTE STATIONS

The master station will accommodate up to 9 connections at the terminal board. These connections can be any combination of remote stations, remote controls or volume controls. It will also accommodate 3 door speaker connections.

If more than 9 stations are required, use the optional

NOTE: NEVER connect more than one remote station to a set of screw terminals.

Model Nº IA-440 expansion kit. This will allow an additional 6 connections at the master.

3