INSTALLATION (Continued)
WARNING! NEVER EXCEED A TOTAL OF 15 NUTONE 25 OHM SPEAKERS ON THIS SYSTEM.
WARNING! NEVER USE STANDARD 8 OHM STEREO SPEAKERS ON THIS SYSTEM. USE ONLY NUTONE SPECIFIED SPEAKERS ON THIS MASTER.
MOUNTING THE TERMINAL BOARD
1.Remove and clean any drywall debris or dust from the
2.Refer to Figure 1. Locate the terminal board in the left rear section of the
3.Use four (4) Nº 6 x 3⁄8“ screws supplied to secure the terminal board to the
4.Make certain the lower
▲ IMPORTANT ▲
DO NOT APPLY POWER TO THE SYSTEM UNTIL ALL CONNECTIONS ARE COMPLETE AT THE MASTER AND REMOTE STATIONS.
FIGURE 1 |
CONNECTING THE REMOTE WIRING
All Remote Stations, Remote Controls, Speaker Volume Controls, and Door Speaker Wiring MUST Return Directly to the Master Station. DO NOT CONNECT WIRING FROM SPEAKER TO SPEAKER!
1.Dress all remote wiring through the rectangular holes in the upper right and left sides of the
2.Refer to Figure 2. Connect the
Connect: RED to RED RED/WHT to RED/WHT BLK to BLK BLK/WHT to BLK/WHT ORN to ORN ORN/WHT to ORN/WHT
Only connect one remote to each set of screw terminals. After completing all connections, check for any shorted wires. Dress cables flat against the terminal board to allow space for the master station to be properly secured.
MOUNTING HOLES |
RED |
RED/WHT |
BLK |
BLK/WHT |
ORN |
ORN/WHT |
FIGURE 2 |
3.Refer to installation instructions packaged with the remote stations and remote controls for wiring these units.
4.Refer to Figure 3. Use the Wire Matching Chart if you are
IMPORTANT – WHEN NUTONE MODEL
CONNECT TO THE
SCREW TERMINALS
ON THE TERMINAL
BOARD MARKED:
1 | ORN |
2 | BLK |
3 | BLK/WHITE |
4 | ORN/WHITE |
5 | RED |
6 | RED/WHITE |
BLUE STRIPE
FIGURE 3
4