Nuvo NV-T2DF manual Back Panel

USE ONLY NuVo

NV-T2PAS

POWERED ANTENNA SYSTEM

AUX IN OUT

L	TRIGGER
	ON=+12V

AUX IN		OUT			Model NV-T2FX
			NuVoNet		FM/AM/WX-XM Tuner
	L	TRIGGER			NuVo Techonlogies LLC•Cincinnati Ohio USA
		ON=+12V	IR PASS-THRU	OUT	www.nuvotechnologies.com
			IN

MADE IN CHINA

R

AUDIO

	USB	RS 232
R	AUDIO
	IR INPUT

IN

ANTENNA INPUT

OUTPUT

TUNER B

OUTPUT

TUNER A SYSTEM

TE RTE	K	INTERTEK
IN
	CM
3033118

90~264V 50~60Hz 15W

1 2 3 4 5 6 7 8 9 10 11 12

Back Panel

1.Antenna Input: Coax “F” connector brings in the signal input from the NuVo NV-T2PAS antenna (pg. 10).

2.Aux. Input: This stereo RCA connector is enabled through the advanced menu options (pg. 14), and allows an additional audio source to be connected and accessed through the tuner source selection.

3.Audio Output: A Stereo RCA output allows the tuner audio signal to be connected to an amplifier source, such as the NuVo Simplese, Essentia, and Concerto audio distribution systems.

4.Trigger ON: The voltage output provides a constant 12 volts when the Tuner is turned on.

5.Audio Output: This is a second stereo output designed to work with a tip, ring, sleeve 3.5mm stereo connection.

6.IR Pass-Thru: This 3.5mm connection is used to link IR control between two or more components used in the same installation.

7.IR Input: The single IR Input accepts a mono 3.5mm patch cable for receiving IR information from an external IR receiver without the use of an external IR emitter.

8.NuVoNet In: This RJ45 connection is used with one of the Peripheral Device inputs on the Concerto EZ Port (see pg. 17) to enable direct one-to-one communication with the Concerto Display Pads.

9.NuVoNet Out: This RJ45 jack is used to link the NuVoNet communication between multiple NuVo Peripheral Devices such as the T2 Tuners in a single installation.

10.USB: The USB port is used for downloading a configuration from your computer (see pg. 17).

11.RS232: This 9-pin DB9 connection allows serial communication with an external RS232 system. This may also be used for downloading a configuration from your computer.

12.AC Power: This connects the T2 with an AC power source. When plugged into a live AC outlet the blue power LED (Light Emitting Diode) on the T2's front panel will remain lighted. When neither tuner is on, the T2 is in standby mode and draws less than 2 watts of power.

Page 6