Blank PWRSW - +
PWRLED

Hardware Installation

Connecting Internal Headers

Front Panel Header

The front panel header on this motherboard is one connector used to connect the following four cables:

‰ PWRLED

 

No

 

Attach the front panel power LED cable to

RESET

these two pins of the connector.

Connect

 

 

 

The Power LED indicates the system’s

9

10

status. When the system is in S0 status,

 

the LED is

 

on. When the system is in S1, S3, S4, S5

 

status, the LED is off.

 

HD_LED

-+

1

2 1

Note: The power LED cable in some chassis is a three pin connector with the pins installed in positions 1 and 3. If your chassis has a three pin connector, you will need to remove pin 3 and put it into position 2 or you can use a pair of scissors to cut out position 2. Most chassis come with a two pin connector.

‰PWRSW

Attach the power button cable from the case to these two pins. Pressing the power button on the front panel turns the system on off rather than using the power supply button.

‰HD_LED

Attach the hard disk drive indicator LED cable to these two pins. The HDD indicator LED indicates the activity status of the hard disks.

‰RESET

Attach the Reset switch cable from the front panel of the case to these two pins. The system restarts when the RESET switch is pressed.

21

Page 33
Image 33
Nvidia 650I manual Connecting Internal Headers, Front Panel Header