![](/images/new-backgrounds/1122027/122027399x1.webp)
Page: 144
Service Guide OJ2010
Chapter 4 Failure and Repair Analysis
4.8.07 Printer Error Log Recovery
This test retrieves the last error from NVRAM.
To run the test, follow this procedure.
1.Power OFF the printer.
2.Move the two pin jumper on connector J13 of the system board to the pin position shown below.
3.Power ON the printer.
4.The test will start.
5.To stop the test, power OFF the printer or unplug the printer.
6.Return the jumper to its original position after completing the test.
7.The last error appears as a series of flashes of the Power ON light. If the Power ON light does not flash, there are no errors.
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)