Menu setting method

4

method setting Menu

[Off]:

Disables this function. Will resume recording in normal mode.

When [Standby] is selected:

[On]: With this setting, the recording monitor (earphone output) is disabled during VCVA standby

(☞ P.34), which allows you to confirm VCVA actuation status by the earphone output.

[Off]: The audio signal is always output from the earphone jack.

Adjust the start/stop actuation level:

1Press the REC (s) button to start recording.

•When the sound volume is lower than the preset threshold sound level, recording automatically stops after

1 sec approximately, and [Standby] flashes on the display. The LED indicator light glows when recording starts and flashes when recording pauses.

2Press the 9or 0button to adjust the start/stop actuation level.

•The VCVA level can be set to any of 23 different values.

•The higher the value, the more sensitive the recorder will be to sounds. At the highest value, even the faintest sound will activate recording.

•When using the [VCVA] function, the following functions are not available.

• [V-Sync. Rec]

•When [Rec Monitor] is set to [Off], the [Standby] function is disabled (☞ P.59).

•If the start/stop actuation level is not adjusted within 2 seconds, the display will return to the previous one.

•If the surrounding noise is loud, the start/ stop actuation sensitivity of the VCVA can be adjusted according to the recording situation.

•To ensure successful recordings, prior testing and adjustment of the start/stop actuation level is recommended.

V-Sync. Rec

Voice sync recording starts when a voice louder than the voice sync level (detection level) is detected. When the voice becomes low, recording will automatically stop. When voice sync recording is on and the input level falls below the voice sync level (detection level) for a period of at least the specified detection time, the recorder will return to the standby mode.

1Select [On] or [Off].

[On]: Enables the Voice sync recording function.

[Off]: Disables this function.

•If you select [On], proceed to the operation of Step 2.

 

a

 

 

 

 

 

b

 

 

 

 

 

aLevel meter (varies according to the

 

 

sound volume being recorded)

EN

bStart level (moves to the right/left

 

according to the set level)

56