Perform the final checks after loading.

After sealing the case, perform the following final checks to confirm proper operation of the camera.

Press the Case’s power switch button to see if the camera can be turned on and off.

Move the mode dial knob on the rear of the Case to see if the camera mode can be switched accordingly.

Press the Case’s shutter level and see if the camera shutter can be released accordingly.

Press other buttons on the Case to see if the camera functions accordingly.

CAUTION : • If the camera does not function properly, restart the digital camera installation procedure from “Check the digital camera.” on page E-14 of this manual.

•Make sure that the mode dial can be moved after the camera has been loaded in the Case. If the mode dial does not move, there may be oil or grease on it; wipe it clean.

Check the shooting scene and shooting scene mode

The position of the camera’s mode dial cannot be seen once the camera is inside the Case. Consequently, the shooting scene and shooting scene mode setting can only be checked on the LCD monitor.

Shooting scene/ shooting scene mode

E-19