Omega DPS3100, DPS3200 manual Display Modes, Setup, Channel Configuration, System Configuration

TABLE OF CONTENTS
SPECIFICATIONS	3
DESCRIPTION	4
DISPLAYING PARAMETERS	5
Table 1. How to Display Parameters	5
DISPLAY MODES	5
Table 2. Display Modes	6
Elapsed Time Mode	6
Scan Mode	6
High/Low Channel Mode	7
Deviation Mode	7
Types of Deviation Displays	7
Difference Mode	8
SETUP	8
'SYS' Parameter List	9
CH Parameter List	9
CHANNEL CONFIGURATION	10
Setup For Input Type	10
Setup for Voltage or Current Input:	10
Setup For Channel ON/OFF	10
Setup For Decimal Point Position	10
Setup For High Scale	10
Setup For Low Scale	11
Setup For Offset	11
Setup For Tare	11
Setup For Setpoint	11
Setup for Universal Relay (Channel 1 Relay)	12
Setup For Limits	12
Setup For Deadband	12
Setup For Relay Normally Open/Closed	12
Setup For Engineering Units	13
Setup for Thermocouple/ Thermistor/ RTD Inputs:	13
Turning Channels ON/OFF:	13
Temperature units:	13
Setup Examples	13
Example #1: Use of the OFFSET Parameter	13
Example #2: Use of the LOW SCALE Parameter	14
Example #3: Use of the TARE Parameter	14
SYSTEM CONFIGURATION	14
Setup For Display Options	14
Table 3. Display Options	14
Setup For Display Time	14
Setup For Relay Latch/Non-Latch	15
Relay Latched Mode:	15
Relay Non-Latched Mode:	15
Setup for Buzzer	15
Setup For Cold Junction Calibration	15
Setup For Channel Calibration	15
Input Range Setup (for current and voltage):	15
Voltage Range Setup (0-10vdc)	15
Voltage Range Setup (for millivolt inputs)	16
Current Range Setup	16
Correct Range Settings	16
Thermocouple Calibration Procedure	16
SAVING PARAMETER:	16
PEAKS	17
PROGRAMMING FLOW CHARTS:	17
RATE	20
LIMITS	20
OUTPUTS	20
Open Collector Option	20
Figure 1. Open Collector Hookup Example	20
	Page 1