Handshaking Xon/Xoff
Once the main menu is present proceed with the station setup procedures as described in the next section.
OPERATION
The
(Figure 3).
Software
The firmware contained in the
The communications parameters required to interface the
Baud rate | 9600 |
|
Data Bits | 8 |
|
Stop Bits | 1 |
|
Parity | None |
|
7 |
Station Setup
Press “Esc” to get to the main menu. Press “1” at the main menu to initiate the Station Setup procedure. This procedure allows you to specify certain operational parameters that the
When you press “1” at the main menu, the parameters available for customizing appear as items 1 through 8.
Station Name
1.Type the name of the station.
2.The station name may be any series of alphanumeric characters up to 50 characters long. After the station name is entered press “Enter” and select the next item.
Units of Measure
Press 2, Units of measure. A warning message will appear stating, “ Changing units will cause data to be logged in the new units of measure”. You should clear logging memory to avoid mixed data values. Do you want to continue? [Y or N]: If you want to change units of measure press ”Y” and the menu will ask you English or Metric? Select E or M and press “Enter”.
The menu will ask if you are sure you want to delete log file [Y or N] if you have changed units then answer “Y” if not “N”. and press “ Enter”.
PARAMETER | ENGLISH | METRIC |
Speed | Mph | M/s |
Direction | Deg | Deg |
Temperature | ºF | ºC |
Humidity | % | % |
Barometer | Inhg | Mb |
Precipitation | inches | mm |
Table 2
Averaging Period
Press 3, Averaging period. The averaging period is user selectable over the range from 1 minute to 60 minutes. The stored data will be the average of the data measured at five- second intervals over the user selected averaging period. If the