-In the right hand window move the slider down and until you see the ‘Network’ settings
-Before proceeding you must speak to your network administrator to get the following information regarding the network you will be connecting the XPort device to:
•The network gateway
•The network subnet
•An available IP address.
-This should ideally be a static IP address.
-The second best would be an assigned address.
-The worst best would be a leased address with a significant time out.
-One of the above must be found. Failure to do so could result in problems communicating with the logger in the event of a reset of the XPort device caused by a power failure.
-When you have an IP address from your network administrator as detailed above note it down here __.__.__.__. This will be required when setting up communications from within SquirrelView.
-If the IP address given to you by your network administrator is different from the one in the column titled ‘IP Address’ above you must perform the following additional step:
Click the address button.
In the displayed dialog type in the IP address given to you by the network administra-
tor. Then click on the 
button
-Next type in the network gateway and subnet values from the network administrator in the Network section shown in the diagram above.
Page 8
