Omega Vehicle Security 850i Using Your Crime Guard System, Upon Arming the System will

USING YOUR CRIME GUARD SYSTEM

Arming the Crime Guard system turns on the antitheft protection, disables the vehicle’s starter and locks the doors (provided an interface is installed). Once the system is Armed, any intrusion attempt will Activate it, sounding the siren and flashing the lights to attract attention. Disarming the system turns off the protection, allowing normal use of the vehicle.

There are three methods of Arming the security system:

1- The first method is to use the transmitter or transceiver, by pressing and releasing its “Arm/Lock” button. The system must not be in Alarm Valet Mode (page 23-24), and the vehicle’s ignition switch must be off. Every press of the “Arm/Lock” button arms the system, even if it is already armed.

2- The second method is to press and release the transmitter or transceiver’s “ II” button twice within 5 seconds. This is “Silent Arming”.

3- The third method is Last Door Arming, which configures the system to automatically arm every time you exit the vehicle. This method of arming is programmable, and may be used or not used as desired.

REMOTE ARMING BY TRANSMITTER OR TRANSCEIVER

To Arm the System:

Press & Release the “Arm/Lock” Button ( U) on Either

THE SIREN CHIRPS TWICE

TO CONFIRM ARMING

THE PARKING LIGHTS

FLASH TWICE

TO CONFIRM

ARMING

THE DOORS WILL LOCK*

Upon Arming the System will:

• The siren will chirp twice (or four times if a zone is bypassed) unless the silent arming procedure is followed.

• The parking lights will flash twice (or four times if a zone is bypassed).

• The doors will lock*.

* An optional doorlock interface must be installed

program the feature, follow Steps 1 to 4 on page 28; at Step 4 the Valet Switch will be pressed and released thirty one times. The system’s response will be thirty one siren chirps, and the Status Light flashing thirty one times, pausing, then repeating. Within 10 seconds, press and release the transmitter’s "Arm/Lock" button to turn on the Turbo Timer feature (the siren will chirp once) or the "Disarm/Unlock" button to turn it off (the siren will chirp twice).

PROGRAMMING TRANSMITTERS

OR ECHO TRANSCEIVERS

Your Crime Guard 850i4e system is capable of being operated by as many as four controllers; these can be any combination of standard Crime Guard transmitters or Omega Echo transceivers. Regardless of which, the transmitter or transceiver must be encoded, or programmed, to the system in order to operate it (excepting the originals, which were programmed at the factory). This programming procedure is identical for a transmitter or Echo transceiver. To program additional or replacement transmitters or transceivers, follow this procedure:

Have all of the transmitters or transceivers at hand (when one is programmed, all others are erased).

Step 1 Turn the vehicle’s ignition “on”.

Step 2 Within 5 seconds of turning "on" the ignition, press the Valet Switch 5 times. The siren will chirp once, confirming that the system is ready to learn a transmitter.

Step 3 Within 10 seconds press and release the “Arm/Lock” button (the “locked padlock” graphic). The siren will chirp once, confirming that the system learned the transmitter.

Step 4 Repeat the previous step for each transmitter or transceiver which is to operate the system.

Only the “Arm/Lock” button is pressed in programming; when it is learned all of the other buttons’ functions are automatically assigned. The system will remove itself from the programming mode if 10 seconds expire without its receiving a signal, if the ignition is turned “off”, or upon four transmitters or transceivers being programmed into the system.

Please note that programming a transmitter to the system will activate the audible Unauthorized Transmitter Alert warning and the extended Status Light

Page 6 Page 43