The Learning Feature
(How to copy functions from your original working remote
onto the ONE FOR ALL 4)
Before you start:
-Make sure your original remote control is working correctly.
-Make sure neither your ONE FOR ALL, nor your original remote control is pointing at your device.
Example: To copy the “mono/stereo” function from your original TV remote onto the ”Red”key of your ONE FOR ALL 4.
1Place both remote controls (the ONE FOR ALL 4 and your original) on a flat surface. Make sure the ends which you normally point at your device are facing each other. Keep the remotes at a distance of 2 to 5 cm.
2 | Press and hold down the MAGIC key |
|
| (for approximately 3 seconds) until the |
|
| red LED (underneath the TV key |
|
| in this example) blinks twice. |
|
| The red LED will blink once, then twice. | x2 |
3
Press 9 7 5 (the red LED will blink twice).
4Press the device key (on the ONE FOR ALL remote) to select the mode to which you want to copy the learned function (Example: TV key).
5Press the key (on the ONE FOR ALL remote) where you want to place the learned function (Example: ”Red” key). The red LED (underneath the TV key in this example)
will flash rapidly.
6Press and hold the key (on your original remote) that you want to copy until the red LED blinks twice
(Example: “mono/stereo” key).
If you want to copy other functions within the same mode, simply repeat steps 5 and 6 pressing the next key you want to copy by learning.
7To exit the learning mode, press and hold down the MAGIC key until the red LED blinks twice.
-Learning is mode specific. To access your learned function, press the appropriate device key first.
-The ONE FOR ALL 4 can learn approximately 100 functions.
-You can replace a learned function by placing another learned function on top.
-Upon changing the batteries, your learned functions will be retained.
WWW. ONEFORALL.COM | 11 |
