One for All URC-8350 warranty Learning Feature, Before you start

The Learning Feature

(How to copy functions from your original working remote

onto the ONE FOR ALL URC 8350)

The URC-8350 comes with a complete library of pre-programmed codes. After you have set up the URC-8350 for your device, you may find that there are one or more keys that you had on your original remote, which do not have a place on the URC-8350 keypad.

As a convenience, the URC-8350 offers a special Learning feature that allows you to copy any function from your original remote control onto the keypad of the URC-8350.

Before you start:

-Make sure your original remote control is working correctly.

-Make sure neither your URC-8350, nor your original remote control is pointing at your device.

Example: To copy the “mono/stereo” function from your original TV remote onto the “LAST” key of your URC-8350.

1.Place both remote controls (the URC-8350 and your original) on a flat surface. Make sure the ends which you normally point at your device are facing each other. Keep the remotes at a distance of 2 to 5 cm.

2.	Press and hold down REWIND + FASTFORWARD
	simultaneously until the URC-8350’s LED (red light)
	blinks twice (the LED will blink once and then twice).
3.	Press 9 7 5 (the LED will blink twice).

4.Press the device key (on the URC-8350 remote) to select the mode to which you want to copy the learned function (example: TV key).

5.Press the key (on the URC-8350 remote) where you want to place the learned function (example: LAST key). The LED will flash rapidly.

6.Press and hold the key (on your original remote) that you want to copy until the LED on the URC-8350 blinks twice (example: “mono/stereo” key).

7.If you want to copy other functions within the same mode, simply repeat steps 5 and 6 pressing the next key you want to copy by learning. If you want to copy other functions to a different mode, then repeat from step 4 onwards and press the applicable mode key.

8.To exit the learning mode, press and hold OK until the

LED blinks twice.

9.Learning is mode specific. To access your learned function, press the appropriate device key first.

-The URC-8350 can learn approximately 25 - 40 functions (depending on the function to be learned). Memory full will be indicated by two long blinks.

-You can replace a learned function by placing another learned function on top.

-Upon changing the batteries, your learned functions will be retained.

WWW.ONEFORALL.COM 7