Oneida Air Systems 10 HP manual Accessories, Multiple Drums

X. Accessories

Angle Iron Stands

STZ350055 - Angle Iron Cyclone Stand

STZ990000 -Plenum Stand

Bin Level Monitor - Provides level sensing for dry bulk solids. The monitor operates by using a 1 rpm synchronous motor to rotate a paddle. When paddle rotation is impeded by material surrounding it, the motor is de-energized and triggers a SPDT snap switch. The snap switch can be used in conjunction with a motor starter to turn equipment off or provide alarm functions.

Magnetic Motor Starters - The 10 and 15hp pulley drive dust collectors do not come wired or with an on/off switch. Because of the voltage and amperage requirements of the system, an industrial switch must be used.

OAS offers Square “D” Full Voltage Non-Reversing across the Line Starters, Nema Type 1 Enclosure with Start/Stop in cover, and class 10 overload. Industrial switches can also be purchased through your local electrician. Due to varying electrical codes, OAS cannot specify exact wiring requirements. When wiring the collector you should always hire a licensed electrician.

Dust Bin Options - (Must Order Custom Cyclone Mounting Stand.)

1. Multiple Drums -

Custom order the System Mounting Stand for multiple drums or hoppers. Stand widths will vary depending on dust container.

2. Hoppers -

Large capacity hoppers from .5 cu. yd. to 3 cu. yd.

3/16” reinforcing angle for added support - 3/16” plate body is 100% continuously MIG welded on inside - 3/8” rear cross brace angle (not 3/16”) - three 3” base channel - All angles are structural not formed.

3. Air Locks -

Rotary air locks provide an alternative to an air tight dust bin for larger volume capacity and less maintenance.

Example - A 10” air lock will drop 1.85 cu. ft. / rev. of material.

4.Cone w/ Clean Out - Optional cone with clean out plate for use with

airlocks..

15

10 HP Pulley Drive Owner’s Manual c O.A.S. 2007