FUNCTION SETUP

If you select “Manual”, follow the following instruction to set the IP address and DNS.

3-a) Use [K/ L] to select “IP Address”, “Subnet Mask” or “Default Gateway”, then press [ENTER]. IP address setting screen will appear. Enter IP address, subnet mask and default gateway with cursor buttons and number buttons.

Others

IP Address Setting

IP Address

xxx . xxx . xxx . xxx

Subnet Mask

xxx . xxx . xxx . xxx

Default Gateway

xxx . xxx . xxx . xxx

then press ‘ENTER’.

•Enter the IP address number after checking the specifications of your router.

•If the IP address number is unknown, check the IP address number of other devices. (e.g. PC connected via LAN cable) and assign a different number from those of other devices.

3-b) After you enter all correctly, press [ENTER].

•Confirmation message will appear. Select “Yes” to complete the settings.

Others

IP Address Setting

Is Setting OK?

 

IP Address

xxx . xxx . xxx . xxx

Subnet Mask

xxx . xxx . xxx . xxx

Default Gateway

xxx . xxx . xxx . xxx

 

 

No

 

Yes

 

3-c) Use [K/ L] to select “Primary DNS” or “Secondary DNS”, then press [ENTER]. DNS setting screen will appear. Enter primary DNS and secondary DNS with cursor buttons and number buttons.

Others

DNS Setting

Primary DNS

xxx . xxx . xxx . xxx

Secondary DNS

xxx . xxx . xxx . xxx

then press ‘ENTER’.

•Enter the numbers instructed by your Internet provider.

•If the number is unknown, check the number of other devices (e.g. PC connected via LAN cable) and assign the same number.

3-d) After you enter all correctly, press [ENTER].

•Confirmation message will appear. Select “Yes” to complete the settings.

Others

DNS Setting

Is Setting OK?

 

Primary DNS

xxx . xxx . xxx . xxx

Secondary DNS

xxx . xxx . xxx . xxx

 

 

No

 

Yes

 

4Press [RETURN] to go back to the previous screen, or press [SETUP] to exit.

Note

•The range of input numbers is between 0 and 255.

•If you enter a number larger than 255, the number will automatically be 255.

•The manually entered number will be saved even if you change the setting to “Auto(DHCP)”.

•When you enter a wrong number, press [CLEAR] to cancel. (the number will be back to “0”.)

•If you want to enter 1 or 2 digit number in one cell, press [B] to move on to the next cell.

•If the entered IP address or the default gateway or primary DNS number is same as the default setting, IP address setting will be set to “Auto(DHCP)”. (The manually entered number will be saved.)

•When IP address setting is set to “Manual”, the setting of DNS setting will automatically be “Manual” and when IP address setting is set to “Auto(DHCP)”, you can set either “Auto(DHCP)” or “Manual” for DNS setting.

•Proxy Setting

1Follow steps 1 to 4 in “Connection Test” on page 52.

2Use [K/ L] to select “Enable(Custom)”, then press [ENTER].

3Use [K/ L] to select “Proxy Setting”, then press [ENTER] repeatedly to select the desired setting.

•For default settings, select “Do Not Use”.

•If you need to change the proxy setting as instructed by your Internet service provider to set the designated proxy address and port, select “Use”.

If you select “Use”, follow the following instructions to set the proxy address and proxy port.

EN

53