Troubleshooting
If you have any problems with the unit, please check the troubleshooting table below first.
For any problems not described in the table, please consult your nearest Onkyo authorized service center.
Symptom | Cause | Remedy |
STANDBY button is pressed, but power does not come on.
• Power cord plug is not properly | • Insert the plug firmly. |
connected to AC outlet. | (See pages 11.) |
Disc is loaded in the disc tray, but playback will not begin.
•Disc is in the disc tray upside down.
•Disc is dirty.
•Moisture has accumulated inside the CD Changer.
•Load the disc with the label facing upward.
•Clean the disc. (See page 23.)
•Remove the disc from the disc tray, place the CD Changer in a warm place and leave the power on for about one hour. (See page 4).
| • | Disc in the disc tray is loaded off- | • | Load the disc properly in the disc | |
|
| center. |
| tray. | |
|
|
|
|
| |
No sound | • | Incomplete or incorrect | • | Insert all plugs firmly into jacks. | |
|
| connections. |
| (See pages | |
|
|
|
|
| |
Disc skipping | • | Disc is dirty. | • | Clean the disc. (See page 23) | |
| • | Disc is scratched. | • | Replace the disc. | |
| • | CD Changer has been bumped. | • | Place the CD Changer in a more | |
|
|
|
| stable location. | |
|
|
|
|
| |
Search time (when moving | • | Disc is dirty. | • | Clean the disc. (See page 23) | |
to a specific track) is | • | Disc is scratched. | • | Replace the disc. | |
extremely long. | |||||
|
|
|
| ||
|
|
|
|
| |
Track numbers cannot be | • | No disc in the tray. | • | Load a disc into the tray. | |
stored in memory. | • | A track number not on the disc is | • | Use only the track numbers on | |
| |||||
|
| being input. |
| the disc. (See pages | |
|
|
|
|
| |
Noise during play | • | Interference from TV | • | Turn off the TV, or move the unit | |
|
|
|
| farther from the TV. |
Remote control does not | • | Battery level is low. |
function. | • | Your position is too far from the |
| ||
|
| unit’s remote control sensor or |
|
| out of the sensor’s detection |
|
| angle. |
•Replace the batteries.
•Remote control is possible within a distance of approximately 5 meters from the unit’s sensor and a detection range of 30°.
(See pages 11.)
•An obstacle exists between you and the unit’s remote control sensor.
•Operate from a different position or remove the obstacle.
The unit does not operate. • A failure occurred in the unit's microprocessor.
•Remove the power plug, wait for approx. 5 seconds, and then re- insert the power plug.
24