Troubleshooting
If you run into problems with the unit, look for a solution below. The problem could also be caused by one of the components connected to the unit, so please also check the manuals of each device.
!Caution
-This unit contains a sophisticated microcomputer for signal processing and control functions. In very rare situations, however, severe interference, noise from an external source, or static electricity may cause it to lock up. If this happens, turn off the unit, wait for about five seconds, and then turn it on again.
-Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit's malfunction. Before you record important data, make sure that the material will be recorded correctly.
Returning Settings to the Defaults
Perform the steps below to return all settings to their default values.
Remove the disc from the player.
"NoDISC" appears in the player's display.
While pressing 
on the unit, press the CD button.
"INIT" appears in the display, followed by "FINISH".
This completes the initialization of the settings.
Power
Problem | Solution | See Page |
|
|
|
No power | Make sure that the power cord is properly plugged into the wall outlet. Also | 16 |
| make sure that the power cord is properly connected to the unit's AC inlet. |
|
|
|
|
Disc Playback |
|
|
|
|
|
|
|
|
|
|
|
Problem | Solution | See Page |
|
|
|
Can not play disc | Make sure that the disc is placed in the disc tray properly, and that the disc is | 17 |
| placed in the tray |
|
|
|
|
| Make sure that the disc is not dirty. | 13 |
|
|
|
| Make sure that this CD player can play the disc. | 12 |
|
|
|
| If there is a risk of condensation, leave the unit for about an hour after turning on | 13 |
| the power before use. |
|
|
|
|
Can not play tracks in the disc's playback order | Turn off any special playback modes (e.g. repeat, memory, or random). | 23 |
|
|
|
It takes too long to select tracks (to find the | Make sure that the disc isn't dirty. Clean the disc surface. If the disc is scratched, | 13 |
specified track) | replace it. |
|
|
|
|
Can not store tracks in memory | Make sure that the disc is placed in the disc tray properly, and that the track | 24 |
| number you are specifying exists on the disc. |
|
|
|
|
30
