Listening to an FM/AM Station—Continued
Using the Remote Controller
Press the number buttons as described in the examples below to select the desired preset channel.
Preset Press channel
8
10
22
represents the tens digit.
Selects an FM/AM station.
Enables you to manually tune in a broadcast station.
(See the following section.)
Adjust the volume level.
(Pressing VOLUME 
increases
the volume level, and pressing VOLUME decreases the level.)
Selects a preset channel.
(Pressing 
selects a lower channel number and pressing 
selects a higher channel number.)
Manually Tuning a Broadcast Station
2
1 
YES/MODE
1Turn on the power to the CD receiver.
2Select FM or AM.
3Press
or 
repeatedly while observing
the display to tune in the desired frequency.
Each press of the button changes the frequency by
0.05MHz for FM and 9 kHz for AM. Pressing and holding down the button for more than one second will change the frequency continuously.
While FM is selected, pressing and holding 
or
down a while, then releasing it, will automati- cally raise (or lower) the frequency.
When using the remote controller, press INPUT 
/
to select FM or AM, and press 
/ 
to tune in the desired frequency.
If FM reception is not good
If reception is poor or much noise is heard, press YES/ MODE to turn off the AUTO indicator and switch to monaural reception. In this way, you can reduce noise or dropped signals. To return to AUTO tuning, press YES/ MODE again.
CD receiver
AUTO 
FM ST
SOURCE
SOURCE
Remote
controller
38
