Before Using This Unit
Installing the Batteries
1 Detach the battery cover by pressing the tab and pulling up the cover.
2 Insert two
Carefully follow the polarity diagram (positive + and negative - symbols) inside the battery com- partment.
3 After batteries are installed and seated correctly, attach the compartment cover.
Notes:
•If the remote controller doesn’t work reliably, try replacing the batteries.
•Don’t mix new and old batteries or different types of batteries.
•If you intend not to use the remote controller for a long time, remove the batteries to prevent damage from leakage or corrosion.
•Expired batteries should be removed as soon as possi- ble to prevent damage from leakage or corrosion.
Using the Remote Controller
To use the remote controller, point it at the CD receiver’s remote control sensor, as shown below.
Remote control sensor
m .5 Approx.) ft (16
CD receiver
Notes:
•The remote controller may not work reliably if the CD receiver is subjected to bright light, such as direct sun- light or
•If another remote controller of the same type is used in the same room, or the CD receiver is installed close to equipment that uses infrared rays, the remote con- troller may not work reliably.
•Don’t put anything, such as a book, on the remote con- troller, because the buttons may be pressed inadvert- ently, thereby draining the batteries.
•The remote controller may not work reliably if the CD receiver is installed in a rack behind colored glass doors. Keep this in mind when installing.
•The remote controller will not work if there’s an obstacle between it and the CD receiver’s remote con-
trol sensor.
5
