Onkyo CR-N7 Connecting an RI Dock Remote Interactive Dock, Connecting External Devices-Continued

Connecting External Devices—Continued

Connecting an RI Dock (Remote Interactive Dock)

The following diagram illustrates how to connect the Onkyo Remote Interactive Dock (RI Dock). Connect the HDD IN jacks on the CD receiver to the AUDIO OUT jacks on the RI Dock.

CD receiver’s rear panel

R L

I N

OUT

I N

OUT

I N

R L

REMOTE

CONTROL

white

red

Analog audio cable (RCA)

red

white An cable that comes with

the compact disc recorder

R ---- L
S VIDEO OUT AUDIO OUT	DC IN

Jacks on the RI Dock’s rear panel

: Signal flow

The jack connection enables you to use the following functions:

•You can control a connected Onkyo RI Dock using the supplied remote controller. You also need to connect the analog audio cable. Please refer to the instruction manual attached to the RI Dock for correct connection. If the HDD device has a MODE switch, you must set the switch to HDD.

•When the connected Onkyo RI Dock plays back, the input selector on the CD receiver is automatically switched to HDD.

•If the source name assigned to HDD jacks is CD-R, it should be reset to HDD (default setting).

Please follow the steps on page 20 to change the source name in the display. Select HDD for the input source in Step 4.

•If a component has two terminals, you can use either one to connect to the CD receiver. The other one can be used to daisy chain with another component.

19