Onkyo DR-L50 TV or projector, Before connecting, ■Connecting to a TV (or projector)

Connecting to a TV (Other than European model)

Before connecting

•Refer also to the instruction manual of the TV.

•When you connect the DVD Receiver to the TV, be sure to turn off the power and unplug both the units from the plugs before making any connections.

•Connect the DVD Receiver to the TV directly. If you connect the DVD Receiver to a VCR, TV/VCR combination, or video selector, the playback picture may be distorted as DVD videos are copy protected.

•Connect the plugs securely.

•Note that one audio/video connection cable and one S video connection cable are supplied.

Incomplete

Insert completely

■Connecting to a TV (or projector)

Using the supplied audio/video connection cable, make audio connections from the TV/LINE IN L and R jacks to the corresponding audio output jacks on the TV. In the same manner, make video connections from the VIDEO OUTPUT “VIDEO” jack to the corresponding video input jack on the TV.

If your TV has a S video input jack and/or component video input jacks, make S video connection to the S VIDEO jack using supplied S video connection cable and/or make component video connection to the COMPONENT jacks using component video connection cable (not supplied). These connections allow you to enjoy higher quality picture playback. You can switch between [S1] and [S2] S-video output from the Setup menu on page 71.

Notes

•Actual labels for component video inputs may vary depending on the TV manufacturer (ex. Y/CB/CR, Y/B-Y/R-Y, etc.).

•In some TVs, the color levels of the playback picture may be reduced slightly or the tint may change. In such a case, adjust the TV for optimum performance.

				Video
				(Yellow)
	TV or projector			L (White)
				Audio/video connection cable
DIGITAL				R (Red)
OUT	AUDIO	VIDEO S VIDEO COMPONENT VIDEO IN
OPTICAL	OUT	IN	IN	Y PBPR
	R L

Use the DIGITAL OPTICAL IN jack in combination with the TV/ LINE IN jack. When you use the Input selector to select TV/LINE IN, DIGITAL OPTICAL IN is also activated. When both a digital signal and an analog signal are input, the digital signal takes precedence.

Y

PB

PR

S video connection cable

Optical fiber cable

Component video connection cable

Signal flow

			L			ANTENNA	SURROUND		FRONT SPEAKERS
PREOUT							SPEAKERS			AC INLET
							R	L	R CENTER L
AUDIO
			REMOTE
			CONTROL
			R		AM	FM 75				DO NOT connect the
SUB	IN	OUT	IN							power cord at this time.
WOOFER	TV/LINE	MD/CDR/TAPE
DIGITAL			VIDEO OUTPUT
OPTICAL			Y	PB	PR

OUT IN S VIDEO VIDEO COMPONENT

See “Turning the unit on/off with the TV’s power switch — IPM function” on page 27 for Inteligent Power Management (IPM) function.

18