Onkyo HT-RC260 instruction manual Source Setup, Theater-Dimensional, Audyssey

Theater-Dimensional

■Listening Angle

`Wide:

Select if the listening angle is 40 degrees.

`Narrow:

Select if the listening angle is 20 degrees.

With this setting, you can optimize the Theater-Dimen- sional listening mode by specifying the angle of the front left and right speakers relative to the listening position. Ideally, the front left and right speakers should be equidistant from the listening position and at an angle close to one of the two available settings.

Front left speaker	Front right speaker
	20°/40°

Source Setup

Items can be set individually for each input selector.

Preparation

Press the input selector buttons to select an input source.

Main menu Source Setup

Audyssey

When Audyssey 2EQ® Room Correction and Speaker Setup is complete, the “Equalizer” setting (➔ 37) will be set to “Audyssey” and the “Dynamic EQ” will be set to “On”.

■Dynamic EQ

`Off:

Audyssey Dynamic EQ™ off.

`On:

Audyssey Dynamic EQ on.

The Dynamic EQ indicator will light (➔ 8).

With Audyssey Dynamic EQ, you can enjoy great sound even when listening at low volume levels. Audyssey Dynamic EQ solves the problem of deterio- rating sound quality as volume is decreased by taking into account human perception and room acoustics. It does so by selecting the correct frequency response and surround volume levels moment-by-moment so that the content sounds the way it was created at any volume level — not just at reference level.

Note

•If Direct listening mode is selected, this setting cannot be selected.

■Reference Level

Audyssey Dynamic EQ Reference Level Offset

`0dB:

It should be used when listening to movies.

`5dB:

Select this setting for content that has a very wide dynamic range, such as classical music.

`10dB:

Select this setting for jazz or other music that has a wider dynamic range. This setting should also be selected for TV content as that is usually mixed at 10 dB below film reference.

`15dB:

Select this setting for pop/rock music or other pro- gram material that is mixed at very high listening levels and has a compressed dynamic range.

Movies are mixed in rooms calibrated for film refer- ence. To achieve the same reference level in a home the- ater system each speaker level must be adjusted so that –30 dBFS band-limited (500 Hz to 2000 Hz) pink noise produces 75 dB sound pressure level at the listening position. A home theater system automatically cali- brated by Audyssey 2EQ will play at reference level when the master volume control is set to the 0 dB posi- tion. At that level you can hear the mix as the mixers heard it.

Audyssey Dynamic EQ is referenced to the standard film mix level. It makes adjustments to maintain the ref- erence response and surround envelopment when the volume is turned down from 0 dB. However, film refer- ence level is not always used in music or other non-film content. Audyssey Dynamic EQ Reference Level Offset provides three offsets from the film level reference

(5 dB, 10 dB, and 15 dB) that can be selected when the mix level of the content is not within the standard.

Note

•If “Dynamic EQ” setting is set to “Off” (➔ 39), this setting cannot be selected.

■Dynamic Volume

`Off:

Audyssey Dynamic Volume™ off.

`Light:

Light Compression Mode becomes active.

`Medium:

Medium Compression Mode becomes active.

`Heavy:

Heavy Compression Mode becomes active. This set- ting affects volume the most, causing all sounds to be of equal loudness.

En

39