■Audio Return Ch (ARC)
`Off
`Auto:
The audio signal from your TV tuner can be sent to the HDMI OUT of the AV receiver.
The audio return channel (ARC) function allows an ARC capable TV to send the audio stream to the HDMI OUT of the AV receiver. To use this function, you must select the TV/CD input selector and your TV must be ARC capable. The ARC indicator will light when the audio signal is detected.
Note
•This setting is fixed to “- - -
•This setting is set to “Auto” automatically when the “HDMI Ctrl (RIHD)” setting is set to “On” for the first time.
•If you set “Audio Return Ch” to “Auto”, the “Audio Selector” settings of the TV/CD input selector will be automatically switched to “ARC” (➔ page 45).
■LipSync
`Off
`On
This function allows the AV receiver to automatically correct any delay between the video and the audio, based on the data from the connected monitor.
Note
•This function works only if your
After changing the settings of the “HDMI Ctrl (RIHD)”, “HDMI Through” or “Audio Return Ch”, turn off the power on all connected pieces of equipment and then turn them on again. Refer to the user’s manuals for all connected pieces of equipment.
■InstaPrevue
These settings apply to “InstaPrevue” of the Home menu (➔ page 33) and specify the preview display of HDMI video streams.
Sub Window
`Multi:
Displays preview thumbnails all at once.
`Single:
Displays preview thumbnails
Position
(with “Sub Window” set to “Multi”)
`Top, Bottom, Left, Right
(with “Sub Window” set to “Single”)
`UpperL, UpperR, LowerL, LowerR
With this setting, you can set the position of preview thumbnails on the TV screen.
Note
•Depending on video signals, the picture may not be properly rendered on the preview thumbnails of InstaPrevue.
|
|
| Advanced Operations |
Network Setup |
| ||
1 | 2 | 3 | 4 “Setup” 5 |
Menu | Network Setup |
After modifying the network settings, you must confirm the changes by executing “Save”.
This section explains how to configure the AV receiver’s network settings manually.
If your router’s DHCP server is enabled, you don’t need to change any of these settings, as the AV receiver is set to use DHCP to configure itself automatically by default (i.e., DHCP is set to “Enable”). If, however, your router’s DHCP server is disabled (you’re for example using static IP), you’ll need to configure these settings yourself, in which case, a knowledge of Ethernet networking is essential.
What’s DHCP?
DHCP (Dynamic Host Configuration Protocol) is used by routers, computers, the AV receiver, and other devices to automatically configure themselves on a network.
What’s DNS?
The DNS (Domain Name System) translates domain names into IP addresses. For example, when you enter a domain name such as www.onkyousa.com in your Web browser, before accessing the site, your browser uses DNS to translate this into an IP address, in this case 63.148.251.142.
■MAC Address
This is the AV receiver’s MAC (Media Access Control) address. This address cannot be changed.
