■DHCP
`Enable
`Disable
This setting determines whether or not the AV receiver uses DHCP to automatically configure its IP Address, Subnet Mask, Gateway, and DNS Server settings.
Note
•If you select “Disable”, you must configure the “IP Address”, “Subnet Mask”, “Gateway”, and “DNS Server” settings yourself.
■IP Address
`Class A:
“10.0.0.0” to “10.255.255.255”
`Class B:
“172.16.0.0” to “172.31.255.255”
`Class C:
“192.168.0.0” to “192.168.255.255”
Enter a static IP address provided by your Internet Service Provider (ISP).
Most routers use Class C IP addresses.
■Subnet Mask
Enter the subnet mask address provided by your ISP (typically 255.255.255.0).
■Gateway
Enter the gateway address provided by your ISP.
■DNS Server
Enter the DNS server address provided by your ISP.
■Proxy URL
To use a Web proxy, enter its URL here.
■Proxy Port
If you’re using a Web proxy, enter a proxy port number here.
Advanced Operations
■Network Standby
`On
`Off
This setting enables or disables control over the network. When enabled, the NET indicator will be
Note
•When set to “On”, the power consumption slightly increases in standby mode.
■Update Notice
`Enable
`Disable
When this setting is enabled, you will be notified if a firmware update via network is available.
Note
•Selecting “Never Remind me” on the notification window will switch this setting to “Disable” (➔ page 18).
•For details on the update notification, see “If the “Update New F/W” window appears.” (➔ page 18).
