Turning On/Off the AV Receiver
8ON/STANDBY
8RECEIVER 
RECEIVER 
Turning On
1 Press 8ON/STANDBY on the front panel. or
Press RECEIVER followed by 8RECEIVER on the remote controller.
The AV receiver comes on and its display lights.
■If the “Update New F/W” window appears.
When a new version of the firmware is available, the notification window “Update New F/W” pops up. This notification only appears when the AV receiver is connected to your home network (➔ page 70). To perform the firmware update, follow the instructions on screen.
Use the q/wand ENTER buttons on the AV receiver or remote controller to select one of the options, and then press ENTER.
`Update Now
Starts the firmware update.
Refer to step 4 of “Update procedure” (➔ page 63).
`Remind me Later
The update notification will pop up again the next time you turn the AV receiver on.
`Never Remind me
Disables the automatic update notification.
Tip
•The update notification window can be enabled or disabled in “Update Notice” (➔ page 49).
Turning On & Basic Operations
Turning Off
1 Press 8ON/STANDBY on the front panel. or
Press RECEIVER followed by 8RECEIVER on the remote controller.
The AV receiver will enter standby mode. To prevent any loud surprises when you turn on the AV receiver, always turn down the volume before you turn it off.
Tip
•The HYBRID STANDBY indicator may light depending on the status of settings (➔ page 40).
•For details on power management settings, see “Auto Standby” (➔ page 46).
