Onkyo Connecting the T-433-Continued, System Connections necessary to use the timers

*En_T433_02.fm Page 11 Tuesday, February 15, 2005 3:09 PM

Connecting the T-433—Continued

System Connections (necessary to use the timers)

To use the T-433’s timers with your other Onkyo Sepa- rate Collection components, connect the power cords, cables, and audio cables as shown below.

Caution:

Make sure that the maximum power requirement of the component connected to the AC OUTLET does not exceed the capacity printed on the T-433’s rear panel (100W).

•Be sure to connect the T-433’s power cord to an unswitched AC outlet, one that supplies power con- tinuously.

•Be sure to make the necessary audio cable connec- tions. Refer to the A-933’s instruction manual for details.

T-433

Connecting an Amplifier

Use the supplied audio cable to connect the T-433’s OUT L/R jacks to the analog input jacks on the ampli- fier, as shown.

To use the system functions, use the supplied

cable to make an connection.

A-933	To
	wall outlet

GND			L
L	L
			B	SPEAKERS			A
R	R
			R	L	R	L	UNSWITCHED	T-433
			R
PHONO (MM)	TUNER	CD	LINE				AC OUTLET
L	L		L				AC 230-240V
							50 Hz
SUBWOOFER							TOTAL 100W MAX.
PREOUT

R	R		R	MODEL NOA. -933	A + B : 8 OHMS MIN. /SPEAKER	Supplied cable	Supplied	cable
OUT	MD	IN	OUT IN	CONTROL	CAUTION: SPEAKER IMPEDANCE
MAIN IN			TAPE/CDR
				INTEGRATED AMPLIFIER	A or B : 4 OHMS MIN. /SPEAKER

C-733

DIGITAL

OUT OPTICAL

ANALOG	CONPACT DISC PLAYER
OUT	MODEL NO. C-733

REMOTE

CONTROL

L

R

Note:

When you use the T-433’s clock or timer functions, connect the T-433’s power cord to an AC outlet that supplies power continuously.

Connecting Another Component’s Power Cord

The T-433 has an AC OUTLET on its rear panel. This can be used to connect the power cord of another audio component that you intend to use with the T-433.

L

R

TUNER

Amplifier

Notes:

•The T-433 has two jacks. They’re both the same, so you can use either one.

•To use , you must make an audio connection between the T-433 and the other component.

•Use only dedicated cables for connections.

•If the T-433 is used with another component from the Onkyo Separate Collection, such as the A-933, refer to its instruction manual as well.

11