Onkyo instruction manual Turning On the T-433, Using the A-933’sRemote Controller

*En_T433_02.fm Page 14 Tuesday, February 15, 2005 3:09 PM

Turning On the T-433

STANDBY/ON

ACCUCLOCK	TUNING PRESET
			CLEAR
STANDBY/ON	KEY MODE	TIMER	MEMORY FM MODE
DISPLAY	BAND		TUNING / PRESET
STANDBY

1	Plug the power cord into a suit-
	able wall outlet (or the AC OUT-
	LET on the A-933’s rear panel).

First Time Setup (European models only)

The very first time you turn on the T-433, the Accuclock function automatically sets the clock by using the CT (Clock Time) information present in RDS radio broad- casts. While the clock is being set, “WAIT” flashes on the display, as shown. It may take up to 5 minutes to set the clock.

When the clock has been set, the message “CLOCK ADJUSTED” scrolls across the display, then the day and time are displayed for a while, as shown.

2

STANDBY/ON

Press the T-433’s [STANDBY/ON] button.

The T-433 turns on, and the STANDBY indicator goes off.

To turn off the T-433, press the [STANDBY/ON] button. The T-433 will enter Standby mode.

The T-433 is not completely shutdown in Standby mode.

The Accuclock function automatically updates the clock daily at 2 A.M., 3 A.M. and 2 P.M.

If the clock is incorrect, see “Setting the Clock Manu- ally” on page 21.

Using the A-933’s Remote Controller

ON			STANDBY
ON			STANDBY
1	2	3	4
5	6	7	8
9	10/0	>10	GROUP

FMAM CLEAR

CD

MD

RC-613S (remote controller supplied with the A-933)

If you’re using the T-433 together with the A-933 amplifier from the Onkyo Separate Collection, press the remote controller’s [ON] button once to turn on the A-933, and press it again to turn on the T-433.

To set the entire system to Standby, press the remote controller’s [STANDBY] button.

Note:

To turn on only the A-933 and T-433, press T-433’s [BAND] button or the remote controller’s [FM] or [AM] button.

14