Roland XV-88 OVERDRIVE→ Delay, DISTORTION→ Chorus, DISTORTION→ Flanger, DISTORTION→ Delay, 135

28: OVERDRIVE→ DELAY

This effect connects an overdrive and a delay in series.

L in	L out
	Balance D
	Balance W
Overdrive	Delay
	Balance W
	Feedback
R in	R out
	Balance D

OD Drive

Adjust the degree of overdrive distortion. The volume will change together with the degree of distortion.

OD Pan (Overdrive Pan) #

Adjust the stereo location of the overdrive sound. L64 is far left, 0 is center, and 63R is far right.

DlyTime (Delay Time)

Adjust the time delay from when the direct sound begins until the delay sound is heard.

Dly Fbk (Delay Feedback Level)

Adjust the proportion (%) of the delay sound that is fed back into the effect. Negative (-) settings will invert the phase.

Delay HF Damp

Chapter 7. Adding Effects

29: DISTORTION→ CHORUS

This effect connects distortion and chorus in series. The parameters are essentially the same as “26: OVERDRIVE→ CHORUS,” with the exception of the following two.

OD Drive → Dist Drive (Specify the amount of distortion.) OD Pan → Dist Pan (Specify the stereo location of the

distortion sound.)

L in	L out
	Balance D
	Balance W
Distortion	Chorus
	Balance W
R in	R out
	Balance D

30: DISTORTION→ FLANGER

This effect connects distortion and flanger in series. The parameters are essentially the same as in “27: OVERDRIVE→ FLANGER,” with the exception of the following two.

OD Drive → Dist Drive (Specify the amount of distortion.) OD Pan → Dist Pan (Specify the stereo location of the

distortion sound.)

Balance D

Chapter 7

Adjust the frequency above which delayed sound fed back to the effect will be cut. If you do not want to cut the high

L in

Feedback

L out

Balance W

frequencies of the feedback, set this parameter to BYPASS.

Delay Balance (Delay Balance) #

Distortion

R in

Flanger

Balance W

R out

Balance D

Adjust the volume balance between the overdrive sound that is sent through the delay and the overdrive sound that is not sent through the delay. With a setting of “D100:0W,” only the overdrive sound will be output. With a setting of “D0:100W,” only the overdrive sound that is sent through the delay will be output.

Level (Output Level)

Adjust the output level.

31: DISTORTION→ DELAY

This effect connects distortion and delay in series. The parameters are essentially the same as in “28:

OVERDRIVE→ DELAY,” with the exception of the following two.

OD Drive → Dist Drive (Specify the amount of distortion.) OD Pan → Dist Pan (Specify the stereo location of the

distortion sound.)

L in	L out
	Balance D
	Balance W
Distortion	Delay
	Balance W
	Feedback
R in	R out
	Balance D

135