Chapter 7. Adding Effects

48: 3D DELAY

This applies a 3D effect to the delay sound. The delay sound will be positioned 90 degrees left and 90 degrees right.

L

 

2-Band

Level

EQ

 

 

3D Delay L

 

 

3D Delay C

 

 

3D Delay R

 

R

 

2-Band

 

 

EQ

Delay C (Delay Time Center)

Adjust the delay time from the direct sound until the center delay sound is heard.

Delay L (Delay Time Left)

Adjust the delay time from the direct sound until the left delay sound is heard.

Delay R (Delay Time Right)

Adjust the delay time from the direct sound until the right delay sound is heard.

Delay C, Delay L and Delay R parameters can be set as a note-value of a specified tempo. In this case, specify the value of the desired note.

When Delay C, Delay L and Delay R are Set as a Note Value

As the specified tempo, you may use either the Patch Tempo (p. 71) or the tempo clock of the XV-88’s system (p. 169).

Fbk (Feedback) #

Adjust the proportion (%) of the delay sound that is to be returned to the input. Positive (+) settings will return the signal to the input with the original phase, while negative (-) settings produce an inverted phase.

Level C (Level Center)

Adjust the volume of the center delay sound.

Level L (Level Left)

Adjust the volume of the left delay sound.

Level R (Level Right)

Adjust the volume of the right delay sound.

HF Damp

Adjust the frequency above which delayed sound fed back to the delay input will be cut.

If you do not want to cut the high frequencies of the feedback, set this parameter to BYPASS.

Out (Output Mode)

Adjust the method that will be used to hear the sound that is output to the OUTPUT jacks. The optimal 3D effect will be achieved if you select SPEAKER when using speakers, or PHONES when using headphones.

Lo G (Low Gain)

Adjust the low frequency gain (amount of boost or cut). Positive (+) settings will emphasize (boost) the low frequency range.

Hi G (High Gain)

Adjust the high frequency gain (amount of boost or cut). Positive (+) settings will emphasize (boost) the high frequency range.

Balance (Effect Balance) #

Sets the volume balance between the direct sound and the effect sound.

With a setting of D100:0W only the direct sound will be output, and with a setting of D0:100W only the effect sound will be output.

Level (Output Level)

Adjust the output level.

146

Page 146
Image 146
Roland XV-88 owner manual Adding Effects 48 3D Delay, 146