Roland XV-88 owner manual Shuffle Delay, 145

Chapter 7. Adding Effects

47: SHUFFLE DELAY								Pan A
Shuffle Delay adds a shuffle to the delay sound, giving the								Adjust the pan of the delay A sound.
sound a bouncy delay effect with a swing feel.								Pan B
								Adjust the pan of the delay B sound.
L in						2-Band	L out
					1	EQ
		Feedback
								Level Balance
			Delay 1
		Delay			2			Sets the balance for the levels of the delay A and the delay B.
R in				Delay 2		2-Band	R out	LowGain (Low Gain)
						EQ
Delay (Delay Time) #								Adjust the low frequency gain (amount of boost or cut).
								Positive (+) settings will emphasize (boost) the low
Adjust the delay time from the direct sound until the delay
								frequency range.
sound is heard.
								Hi Gain (High Gain)
								Adjust the high frequency gain (amount of boost or cut).
	Delay parameter can be set as a note-value of a specified
	tempo. In this case, specify the value of the desired note.							Positive (+) settings will emphasize (boost) the high
								frequency range.
	When Delay is Set as a Note Value							Balance (Effect Balance) #
	As the specified tempo, you may use either the Patch							Sets the volume balance between the direct sound and the
	Tempo (p. 71) or the tempo clock of the XV-88’s system							effect sound.
	(p. 169).							With a setting of D100:0W only the direct sound will be
								output, and with a setting of D0:100W only the effect sound
Shuffle (Shuffle Rate) #								will be output.
Sets the ratio (as a percentage) of the time that elapses before								Level (Output Level)
the sound plays in Delay B relative to the time that elapses								Adjust the output level.
before the sound plays in Delay A. When set to 100%, the
delay times are the same.

Accel (Acceleration)

Adjust the time over which the Delay Time will change from the current setting to a newly specified setting. The rate of change for the Delay Time directly affects the rate of pitch change.

Fbk (Feedback) #

Adjust the proportion (%) of the delay sound that is to be returned to the input. Positive (+) settings will return the signal to the input with the original phase, while negative (-) settings produce an inverted phase.

HF Damp

Adjust the frequency above which delayed sound fed back to the delay input will be cut.

If you do not want to cut the high frequencies of the feedback, set this parameter to BYPASS.

Chapter 7

145