Roland XV-88 owner manual Selecting a Part You Want to Play on the Keyboard

3. Confirm that the [EDIT] and [LOCAL/TX] indicators are

extinguished, and, press a Function button to select the

Zone linked to the Part you want played, lighting the

button’s indicator. When the [1-8/9-16] indicator is out,

zones 1–8 can be selected, and when the [1-8/9-16]

indicator is lit, zones 9–16 can be selected.

The Local Switch for the selected zone will be turned

ON.

Chapter 2. Playing

Playing Along with Song Playback (XV-88 Used as a Multi-timbral Sound Generator)

In a Single Performance, you can sound the single specified Part (current Part), making this convenient in such situations as when performing along with songs.

Chapter 2

At the factory settings, there is a one-to-one

correspondence between each of the Zones 1–16 and

Parts 1–16.

The setting here is linked to the setting at the Local

parameter (ZONE/MIDI/MIDI) (p. 60).

4. Repeat Step 3 to set the Local switch to ON for all Zones

Part 1	Part 2
(Rx ch.1)	(Rx ch.2)

(Tx ch.1)

Part 15

(Rx ch.15)

Part 16

(Rx ch.16)

	linked to the Parts you want to have play.
5.	Press [ZONE], getting the indicator to light, and then
	press the [KEY RANGE] function button to access the
	KEY RANG page.
6.	Turn off the [EDIT] indicator, and press a Function
	button to select the Zone whose Local switch is set to
	ON. When the [1-8/9-16] indicator is out, zones 1–8 can
	be selected, and when the [1-8/9-16] indicator is lit,
	zones 9–16 can be selected.
7.	Specifies the keyboard range for the Zone. Use the cursor
	buttons to move the cursor to “Lower” and set the lowest
	note of the range. Move the cursor to “Upper” and set the
	highest note of the range.
8.	Rotate the VALUE dial or press [INC/+]/[DEC/-] to
	specify the range of notes.
	By specifying sections for different Zones so that they
	overlap each other, you can combine two or more
	Patches only in a specific section.
9.	When you are finished making settings, press [EXIT] to
	return to the PERFORM PLAY page, and begin playing.

Selecting a Part You Want to Play on the Keyboard

If a Single Performance is selected, press Function button to select the Part you want to play. The selected Part is called the Current Part.

1.Make sure the PERFORM PLAY page is displayed.

2.Confirm that the [EDIT] indicator is extinguished, and press the Function button to select the Part you want to play using the keyboard. When the [1-8/9-16] indicator is out, Parts 1–8 can be selected, and when the [1-8/9-16] indicator is lit, Parts 9–16 can be selected.

The Part number shown in the upper right of the display will change.

•You can also select the Part by pressing or .

•The keyboard controller’s performance data will be transmitted on the same MIDI channel as the MIDI Receive channel that is set for the current Part.

37