Filter Type

OFF: A filter will not be used.

LPF: The frequency region above the Cutoff Freq setting will be cut.

HPF: The frequency region below the Cutoff Freq setting will be cut.

Cutoff (Cutoff Frequency)

Sets the cutoff frequency when a specific frequency band is cut off by a filter.

Out (Output Mode)

Adjust the method that will be used to hear the sound that is output to the OUTPUT jacks. The optimal 3D effect will be achieved if you select SPEAKER when using speakers, or PHONES when using headphones.

Lo G (Low Gain)

Adjust the low frequency gain (amount of boost or cut). Positive (+) settings will emphasize (boost) the low frequency range.

Hi G (High Gain)

Adjust the high frequency gain (amount of boost or cut). Positive (+) settings will emphasize (boost) the high frequency range.

Balance #

Adjust the volume balance between the direct sound and the flanger sound.

With a setting of D100:0W only the direct sound will be output, and with a setting of D0:100W only the flanger sound will be output.

Lev (Output Level)

Adjust the output level.

Chapter 7. Adding Effects

61: 3D FLANGER

This applies a 3D effect to the flanger sound. The flanger sound will be positioned 90 degrees left and 90 degrees right.

L

2-Band

L out

EQ

 

 

 

3D Flanger

 

R

2-Band

R out

EQ

 

 

Pre Dly (Pre Delay Time)

Adjust the time delay from the direct sound until the flanger sound is heard.

Rate (LFO Rate) #

Adjust the modulation speed of the flanger sound.

Rate parameter can be set as a note-value of a specified tempo. In this case, specify the value of the desired note.

When Rate is Set as a Note Value

As the specified tempo, you may use either the Patch

 

7

Tempo (p. 71) or the tempo clock of the XV-88’s system

Chapter

(p. 169).

 

 

 

Depth (LFO Depth)

Adjust the modulation depth of the flanger sound.

Fbk (Feedback) #

Adjust the proportion (%) of the flanger sound that is to be returned to the input. Positive (+) settings will return the signal to the input with the original phase, while negative (-) settings produce an inverted phase. Higher settings will produce a more distinctive sound.

Phase

Adjust the spaciousness of the flanger sound.

Filter (Filter Type)

OFF: No filter is used.

LPF: The frequency region above the Cutoff Freq setting will be cut.

HPF: The frequency region below the Cutoff Freq setting will be cut.

Cutoff (Cutoff Frequency)

Sets the cutoff frequency when a specific frequency band is cut off by a filter.

153

Page 153
Image 153
Roland XV-88 owner manual 61 3D Flanger, 153