Roland XV-88 owner manual OVERDRIVE→ Chorus, OVERDRIVE→ Flanger, 134

Chapter 7. Adding Effects

26: OVERDRIVE→ CHORUS

This effect connects an overdrive and a chorus in series.

L in L out

27: OVERDRIVE→ FLANGER

This effect connects an overdrive and a flanger in series.

Balance D

	Balance D
	Balance W
Overdrive	Chorus

L in

Feedback

L out

Balance W

	Balance W
R in	R out
	Balance D

OD Drive

Overdrive

R in

Flanger

Balance W

R out

Balance D

Adjust the degree of overdrive distortion. The volume will change together with the degree of distortion.

OD Pan (Overdrive Pan) #

Adjust the stereo location of the overdrive sound. L64 is far left, 0 is center, and 63R is far right.

Cho Dly (Chorus Pre Delay Time)

Adjust the time delay from when the direct sound begins until the chorus sound is heard.

ChoRate (Chorus Rate)

Adjust the modulation speed of the chorus effect.

Chorus Depth

Adjust the modulation depth of the chorus effect.

Chorus Balance #

Adjust the volume balance between the overdrive sound that is sent through the chorus and the overdrive sound that is not sent through the chorus. With a setting of “D100:0W,” only the overdrive sound will be output. With a setting of “D0:100W,” only the overdrive sound that is sent through the chorus will be output.

Level (Output Level)

Adjust the output level.

OD Drive

Adjust the degree of overdrive distortion. The volume will change together with the degree of distortion.

OD Pan (Overdrive Pan) #

Adjust the stereo location of the overdrive sound. L64 is far left, 0 is center, and 63R is far right.

Flg Dly (Flanger Pre Delay Time)

Adjust the time delay from when the direct sound begins until the flanger sound is heard.

FlgRate (Flanger Rate)

Adjust the modulation speed of the flanger effect.

Flg Dpt (Flanger Depth)

Adjust the modulation depth of the flanger effect.

Flg Fbk (Flanger Feedback Level)

Adjust the proportion (%) of the flanger sound that is fed back into the effect. Negative (-) settings will invert the phase.

Flanger Balance #

Adjust the volume balance between the overdrive sound that is sent through the flanger and the overdrive sound that is not sent through the flanger. With a setting of “D100:0W,” only the overdrive sound will be output. With a setting of “D0:100W,” only the overdrive sound that is sent through the flanger will be output.

Level (Output Level)

Adjust the output level.

134