Chapter 7. Adding Effects

Applying Effects in Patch Mode or Rhythm Set Mode

Only one Multi-effect, Chorus, or Reverb effect can be set for each Patch or Rhythm Set. You cannot apply differing types of Multi-effects, Chorus, or Reverb to each of the Tones or Rhythm Tones comprising the Patch or Rhythm Set.

Basic Process of Making Effects Settings

When applying effects in Patch/Rhythm Set mode, the

following procedure is used to make the settings.

1.Setting the Output Method of the Direct Sound (Output Assign)

Settings determining whether or not the signal passes through the Multi-effects, the jack used to output the sound, and the type of output (stereo or mono) are made for each individual Patch or Rhythm Set, or each Tone or Rhythm Tone. → (p. 108, p. 109)

2.Setting the Amount of Each Effect Applied (Send Level)

Set the level (volume) of each effect signal to be sent for each Tone or Rhythm Tone. → (p. 110)

3. Making Multi-Effects Settings

Select the type of Multi-effects to be used, and set the parameters for the selected Multi-effect. → (p. 114, p. 115)

4. Setting the Multi-Effects Controller

When using MIDI messages to change the Multi-effects parameters in realtime, select the Multi-effects controller. →

(p. 115)

5.Setting the Output Destination and Volume for the Sounds Passing Through the Multi- Effects

Select the output jack and set the output level (volume) of the sounds passing through the Multi-effects. You can also apply Chorus or Reverb to the sound that passes through Multi- effects. → (p. 116)

6. Making Chorus Settings

Select the Chorus type to be used, and set each of the parameters for the selected Chorus. → (p. 156, p. 157)

7.Setting the Output Destination and Volume for the Sounds Passing Through the Chorus

Select the output jack and set the output level (volume) of the

sounds passing through the Chorus. You can also apply Reverb to the sound that passes through Chorus. → (p. 158)

8. Making Reverb Settings

Select the Reverb type to be used, and set each of the parameters for the selected Reverb. → (p. 159)

9.Setting the Output Destination and Volume for the Sounds Passing Through the Reverb

Select the output jack and set the output level (volume) of the sounds passing through the Reverb. → (p. 160)

106

Page 106
Image 106
Roland XV-88 owner manual Applying Effects in Patch Mode or Rhythm Set Mode, Basic Process of Making Effects Settings, 106