Roland XV-88 owner manual Keysync Flanger, 140

Chapter 7. Adding Effects

X-Fbk (Cross Feedback Level)

Adjust the proportion (%) of the phaser sound that is to be returned to the input. Positive (+) settings will return the signal to the input with the original phase, while negative (-) settings produce an inverted phase.

Step Rate (Step Rate Switch/Step Rate #)

Adjust the frequency of pitch change.

This setting determines whether the pitch is changed in a stepped fashion (ON) or not (OFF).

Step Rate parameter can be set as a note-value of a specified tempo. In this case, specify the value of the desired note.

When Step Rate is Set as a Note Value

As the specified tempo, you may use either the Patch Tempo (p. 71) or the tempo clock of the XV-88’s system (p. 169).

Mix (Mix Level)

Adjust the volume of the phase-shifted sound, relative to the direct sound.

LowGain (Low Gain)

Adjust the low frequency gain (amount of boost or cut). Positive (+) settings will emphasize (boost) the low frequency range.

Hi Gain (High Gain)

Adjust the high frequency gain (amount of boost or cut). Positive (+) settings will emphasize (boost) the high frequency range.

Level (Output Level)

Adjust the output level.

42: KEYSYNC FLANGER

Keysync FLanger controls the Flanger by resetting the effect at the volume of the sound input to the effects device, restarting from the same pitch each time the Flanger is reset.

This parameter lets your playing dynamics on the keyboard control the flanger effect.

L in	2-Band	L out
	EQ
	Flanger
	Feedback
	Feedback
	Flanger
R in	2-Band	R out
	EQ

Pre Dly (Pre Delay Time)

Adjust the time delay from the direct sound until the flanger sound is heard.

Rate (LFO Rate) #

Adjust the modulation frequency of the flanger sound.

Rate parameter can be set as a note-value of a specified tempo. In this case, specify the value of the desired note.

When Rate is Set as a Note Value

As the specified tempo, you may use either the Patch Tempo (p. 71) or the tempo clock of the XV-88’s system (p. 169).

Depth (LFO Depth)

Adjust the modulation depth of the flanger sound.

Fbk (Feedback) #

Adjust the proportion (%) of the flanger sound that is to be returned to the input. Positive (+) settings will return the signal to the input with the original phase, while negative (-) settings produce an inverted phase. Higher settings will produce a more distinctive sound.

Phase

Adjust the spaciousness of the flanger sound.

Filter (Filter Type)

OFF: A filter will not be used.

LPF: he frequency region above the Cutoff Freq setting will be cut.

HPF: The frequency region below the Cutoff Freq setting will be cut.

140