Chapter 7. Adding Effects

INDIV 3: Output to the INDIVIDUAL 3 jack in mono without passing through Multi-effects.

INDIV 4: Output to the INDIVIDUAL 4 jack in mono without passing through Multi-effects.

The value on the right sets the volume of the Tone or Rhythm Tone. When Multi-effects are being applied, this sets the amount of the effect that is applied; when Multi-effects are not applied, this sets the volume of the direct sound.

When the Output Assign parameter (PATCH/

COMMON/PATCH COMMON)/(RHYTHM/ COMMON/RHYTHM COMMON) is set to anything but TONE, the setting made here has no effect (p. 108).

When the Type parameter (PATCH/COMMON/ STRUCT) has a setting of Type 2–10, the outputs of Tones 1 and 2 will be combined with Tone 2, and the outputs of Tones 3 and 4 will be combined with Tone 4. For this reason, the setting of Tone 1 will follow the setting of Tone 2, and the setting of Tone 3 will follow the setting of Tone 4 (p. 73).

When outputting in mono, the Pan setting is disabled.

When the settings are such that signals are split and output from the INDIVIDUAL 1 jack and INDIVIDUAL 2 jack, and no plug is inserted in the INDIVIDUAL 2 jack, the sounds from INDIVIDUAL 1 and INDIVIDUAL 2 are mixed together, then output from the INDIVIDUAL 1 jack. This sound comprises the sounds from the INDIVIDUAL 1 and 2 jacks.

If the Mix/Parallel parameter (SYSTEM/SETUP/ SYSTEM SETUP) is set to MIX, all sounds are output from the OUTPUT A (MIX) jacks in stereo (p. 169).

When setting the MFX, set the output destination with the Output parameter (PATCH/EFFECTS/PATCH MFX OUT)/(RHYTHM/EFFECTS/RHYTHM MFX OUT) for the sound after it has passed through the Multi-effects (p. 116).

Chorus and Reverb are output in mono at all times.

The output destination of the signal after passing through the chorus is set with Output Assign parameter or Select parameter (PATCH/EFFECTS/PATCH CHO OUT)/(RHYTHM/EFFECTS/RHYTHM CHO OUT) (p. 158).

The output destination of the signal after passing through the reverb is set with Output Assign parameter (PATCH/EFFECTS/PATCH REV OUT)/(RHYTHM/ EFFECTS/RHYTHM REV OUT) (p. 160).

For more on how to set each effect, refer to the pages shown below.

Multi-effects → (p. 114)

Chorus →

(p. 156)

Reverb →

(p. 158)

Chorus (Chorus Send Level)

Sets the chorus depth for individual Tone/Rhythm Tone. If you don’t want to add the Chorus effect, set it to 0.

Reverb (Reverb Send Level)

Sets the reverb depth for individual Tone/Rhythm Tone. If you don’t want to add the Reverb effect, set it to 0.

5.Either rotate the VALUE dial or press [INC/+]/[DEC/-] to set the value.

6.Press [EXIT] to return to the PATCH PLAY/RHYTHM PLAY page.

An asterisk * will be displayed at the left of the Patch/ Rhythm Set group. This indicates that the Patch/Rhythm Set settings have been modified.

If you select another Patch/Rhythm Set in the group with an asterisk *, the modified Patch/Rhythm Set settings will be lost. To keep these modified settings, perform the save operation (p. 164).

110

Page 110
Image 110
Roland XV-88 owner manual 110, Chorus Chorus Send Level, Reverb Reverb Send Level