Roland XV-88 owner manual Chorus/Delay, Flanger/Delay, Chorus/Flanger, Stereo Phaser, 139

38: CHORUS/DELAY

This effect connects a chorus and a delay in parallel. The parameters are the same as for “35: CHORUS→ DELAY.” However, the Delay Balance parameter adjusts the volume balance between the direct sound and the delay sound.

Balance D

L in L out

Chorus Balance W

Feedback

Delay Balance W

R in R out

Balance D

39: FLANGER/DELAY

This effect connects a flanger and a delay in parallel. The parameters are the same as for “36: FLANGER→ DELAY.” However, the Delay Balance parameter adjusts the volume balance between the direct sound and the delay sound.

Balance D

L in L out

Flanger Balance W

Feedback

Feedback

Delay Balance W

R in R out

Balance D

40: CHORUS/FLANGER

This effect connects a chorus and a flanger in parallel. The parameters are the same as for “37: CHORUS→ FLANGER.” However, the Flanger Balance parameter adjusts the volume balance between the direct sound and the flanger sound.

Balance D

L in L out

Chorus Balance W

Feedback

Flanger Balance W

R in R out

Balance D

Chapter 7. Adding Effects

41: STEREO PHASER

This is a stereo phaser. With the Step effects, you can also make stepped changes in the pitch of sounds to which the Phaser effect is applied.

L in	Phaser	2-Band	L out
		EQ
		Mix
		Mix
R in	Phaser	2-Band	R out
		EQ

Type (Phaser Type)

Selects the type of Phaser.

Type 2 adds more of the Phaser effect to the high frequencies than Type 1.

Mode

Selects the number of stages in the phaser (4/8).

Pol (Polarity)

Selects whether the left and right phase of the modulation will be the same or the opposite.

INVERSE: The left and right phase will be opposite. When using a mono source, this spreads the sound.

SYNCHRO: The left and right phase will be the same. Select this when inputting a stereo source.

Man (Manual) #

Adjusts the center frequency to which the phase effect is applied.

Rate (Phaser Rate) #

Adjust the frequency of modulation.

Rate parameter can be set as a note-value of a specified tempo. In this case, specify the value of the desired note.

When Rate is Set as a Note Value

As the specified tempo, you may use either the Patch Tempo (p. 71) or the tempo clock of the XV-88’s system (p. 169).

Depth (Phaser Depth)

Adjust the depth of modulation.

Res (Phaser Resonance)

Adjust the amount of feedback for the phaser. Higher settings will give the sound a stronger character.

Chapter 7

139