Roland XV-88 owner manual Time Control Delay, 22 2VOICE Pitch Shifter, 131

21: TIME CONTROL DELAY

This effect allows you to use a specified controller (the controller selected in Multi-effects Control Source) to control the delay time and pitch in realtime (Multi-effects Controller p. 115). Lengthening the delay will lower the pitch, and

Chapter 7. Adding Effects

22: 2VOICE PITCH SHIFTER

A Pitch Shifter shifts the pitch of the direct sound. This 2- voice pitch shifter has two pitch shifters, and can add two pitch shifted sounds to the direct sound.

Balance D

shortening it will raise the pitch.

L in	2-Band	L out
	EQ
Balance D
	Balance W
Time Control Delay
Feedback	Balance W
	2-Band
R in		R out
	EQ
Balance D

L in

Level Balance A

2Voice Pitch Shifter

Level Balance B

R in

	L out
PanA L	Balance W

PanA R

PanB L

PanB R Balance W

R out

Delay (Delay time) #

Adjust the time delay from the direct sound until when each delay sound is heard.

Accel (Acceleration)

This parameter adjusts the time over which the Delay Time will change from the current setting to a newly specified setting. The rate of change for the Delay Time directly affects the rate of pitch change.

Fbk (Feedback Level) #

Adjust the proportion (%) of the delay sound that is fed back into the effect. Negative (-) settings will invert the phase.

HF Damp

Adjust the frequency above which sound fed back to the effect will be cut. If you do not want to cut the high frequencies of the feedback, set this parameter to BYPASS.

Pan (Output Pan)

Adjust the stereo location of the delay sound. L64 is far left, 0 is center, and 63R is far right.

LowGain (Low Gain)

Adjust the gain of the low frequency range.

Hi Gain (High Gain)

Adjust the gain of the high frequency range.

Balance (Effect Balance)

Adjust the volume balance between the direct sound and the delay sound. With a setting of D100:0W only the direct sound will be output, and with a setting of D0:100W only the delay sound will be output.

Level (Output Level)

Adjust the output level.

Balance D

CoarseA (Coarse Pitch A) #1

Adjust the pitch of Pitch Shift A in semitone steps (-2–+1 octaves).

Fine A (Fine Pitch A) #1

Make fine adjustments to the pitch of Pitch Shift A in 2-cent steps (-100–+100 cents).

One cent is 1/100th of a semitone.

Pan A (Output Pan A)

Adjust the stereo location of the Pitch Shift A sound. L64 is far left, 0 is center, and 63R is far right.

PreDlyA (Pre Delay Time A)

Adjust the time delay from when the direct sound begins until the Pitch Shift A sound is heard.

CoarseB (Coarse Pitch B) #2

Adjust the pitch of Pitch Shift B in semitone steps (-2–+1 octaves).

Fine B (Fine Pitch B) #2

Make fine adjustments to the pitch of Pitch Shift B in 2-cent steps (-100–+100 cents).

One cent is 1/100th of a semitone.

Pan B (Output Pan B)

Adjust the stereo location of the Pitch Shift B sound. L64 is far left, 0 is center, and 63R is far right.

PreDlyB (Pre Delay Time B)

Adjust the time delay from when the direct sound begins until the Pitch Shift A sound is heard.

Mode (Pitch Shifter Mode)

Higher settings of this parameter will result in slower response, but steadier pitch.

Chapter 7

131