The output destination of the signal after passing through the chorus is set with Output Assign parameter or Select parameter (PATCH/EFFECTS/PATCH CHO OUT)/(RHYTHM/EFFECTS/RHYTHM CHO OUT) (p. 158).

The output destination of the signal after passing through the Reverb is set with the Output Assign parameter (PATCH/EFFECTS/PATCH REV OUT)/ (RHYTHM/EFFECTS/RHYTHM REV OUT) (p. 160).

For more on how to set each effect, refer to the pages shown below.

Multi-effects → (p. 114)

Chorus →

(p. 156)

Reverb →

(p. 158)

5.Press [EXIT] to return to the PATCH PLAY/RHYTHM PLAY page.

An asterisk * will be displayed at the left of the Patch/ Rhythm Set group. This indicates that the Patch/Rhythm Set settings have been modified.

If you select another Patch/Rhythm Set in the group with an asterisk *, the modified Patch/Rhythm Set settings will be lost. To keep these modified settings, perform the save operation (p. 164).

Chapter 7. Adding Effects

The Settings for Each Tone/ Rhythm Tone

You can set the direct sound’s output method and the amount of effect applied for each Tone or Rhythm Tone individually.

1.After confirming you are in Patch/Rhythm Set mode, select the desired Patch or Rhythm Set (p. 29, p. 39).

2.Press [EDIT] to make the indicator light up, press the

[EFFECTS] function button, and press or to display the OUTPUT page.

3.Choose the Tone/Rhythm Tone for which you want to make settings.

When Selecting a Tone

After turning off the [EDIT] indicator, use TONE SELECT [1]–[4] to select the tone.

When Selecting a Rhythm Tone

Press the key that accesses the Rhythm Tone you wish to set. After turning off the [EDIT] indicator, you can also use TONE SELECT [1]–[4] to select the following setting.

TONE SELECT [1]: move to an octave lower key

TONE SELECT [2]: move to the semitone below

TONE SELECT [3]: move to the semitone above

TONE SELECT [4]: move to an octave higher key

4.Press or to move the cursor to the parameter you’re going to modify.

Output Assign (Output Assign/Output Level)

Sets the direct sound’s output method and volume for each Tone or Rhythm Tone.

MFX: Output in stereo through Multi-effects. You can also apply Chorus or Reverb to the sound that passes through Multi-effects.

OUTPUT A: Output to the OUTPUT A (MIX) jacks in stereo without passing through Multi-effects.

OUTPUT B: Output to the OUTPUT B jacks in stereo without passing through Multi-effects.

INDIV 1: Output to the INDIVIDUAL 1 jack in mono without passing through Multi-effects.

INDIV 2: Output to the INDIVIDUAL 2 jack in mono without passing through Multi-effects.

Chapter 7

109

Page 109
Image 109
Roland XV-88 owner manual Settings for Each Tone/ Rhythm Tone, 109, When Selecting a Tone, When Selecting a Rhythm Tone