Roland XV-88 owner manual Applying Effects Performance Mode, 111

Applying Effects in

Performance Mode

Only one Multi-effect, Chorus, or Reverb effect can be set for each Performance. You cannot apply differing types of Multi- effects, Chorus, or Reverb to each of the Parts comprising the Performance.

When adding effects in Performance mode, the settings for the Patches or Rhythm Sets assigned to the Parts are disabled, and the effect settings for the Performance go into effect. Thus, the effects for the same Patch or Rhythm Set may differ when played in Patch/Rhythm Set mode and in Performance mode. However, depending on the settings, you can have effect settings for a Patch or Rhythm Set assigned to a Part applied to the entire Performance (p. 114).

Basic Process of Making Effects Settings

When applying effects in Performance mode, the following

procedure is used to make the settings.

1.Setting the Output Method Used by the Direct Sound (Output Assign)

Settings determining whether or not the signal passes through the Multi-effects, the jack used to output the sound, and the type of output (stereo or mono) for each Part. You can also settings for a Patch or Rhythm Set assigned to a Part.

→(p. 113)

2.Setting the Amount of Each Effect Applied (Send Level)

Sets the level (volume) of each effect signal to be sent for each Part. → (p. 113)

3. Making Multi-Effects Settings

Select the type of Multi-effects to be used, and set the parameters for the selected Multi-effect. You can also Multi- effects settings for a Patch or Rhythm Set assigned to a Part.

→(p. 114, p. 115)

4. Setting the Multi-Effects Controller

When using MIDI messages to change the Multi-effects parameters in realtime, select the Multi-effects controller. →

(p. 115)

5.Setting the Output Destination and Volume for the Sounds Passing Through the Multi- Effects

Select the output jack and set the output level (volume) of the sounds passing through the Multi-effects. You can also apply Chorus or Reverb to the sound that passes through Multi- effects. → (p. 116)

Chapter 7. Adding Effects

6. Making Chorus Settings

Select the Chorus type to be used, and set each of the parameters for the selected Chorus. → (p. 156, p. 157)

7.Setting the Output Destination and Volume for the Sounds Passing Through the Chorus

Select the output jack and set the output level (volume) of the

sounds passing through the Chorus. You can also apply Reverb to the sound that passes through Chorus. → (p. 158)

8. Making Reverb Settings

Select the Reverb type to be used, and set each of the parameters for the selected Reverb. → (p. 159)

9.Setting the Output Destination and Volume for the Sounds Passing Through the Reverb

Select the output jack and set the output level (volume) of the sounds passing through the Reverb. → (p. 160)

Chapter 7

111