Onkyo TX-DS696 appendix Connecting speakers, Connecting the speaker cable, Connecting a subwoofer

Connecting speakers

Connecting the speaker cable

Connecting a subwoofer

1.Strip away 5/8 inch (15 mm) of wire insulation.

2.Twist wire ends very tight.

3.Unscrew

4.Insert wire

5.Screw

1 2

15mm

(5/8")

Use the PRE OUT SUBWOOFER jack to connect a subwoofer with a built-in power amplifier. If your subwoofer does not have a built-in amplifier, connect an amplifier to the PRE OUT SUBWOOFER jack and the subwoofer to the amplifier.

Connecting the remote zone speakers

The TX-DS696 allows you to connect another set of speakers and place them in a different room or separated area for listening to music. This other room or area is referred to as the remote zone (Zone 2), while the room where the TX-DS696 is located is the main zone. The diagram below shows how to make the proper connections for the remote zone.

345

Note:

It is important to be aware of the speaker impedance.

Front right	Front left	Surround right	Surround left
speaker	speaker	speaker	speaker

ZONE 2

Zone 2	Zone 2
left	right
speaker	speaker

ANTENNA				COMPONENT VIDEO						FRONT	CENTER
	Y	PB	PR	Y	PB	PR	Y	PB	PR	SPEAKERS	SPEAKER
										R	L
AM
		OUTPUT			INPUT 1			INPUT 2
		IN	OUT	IN	OUT	IN	IN	IN
									VIDEO
FM	MONITOR	DVD	VIDEO 1		VIDEO 2		VIDEO 3 VIDEO 4
75	OUT
	REMOTE
	CONTROL								S VIDEO
										AV RECEIVER
PHONO CD	OUT TAPE IN									MODEL NO.	: TX-DS696

L				L
R				R	PRE OUT
FRONT	SURR	CENTER		FRONT	SURR	CENTER
			OPTICAL	COAXIAL
	L	1	2	L		1
GND				1
				R		2
				2
	R	SUB
SUBWOOFER		WOOFER

SURROUND

SPEAKERS

RL

AC OUTLET

SWITCHED 100W MAX.

ZONE 2

SPEAKERS

RL

CAUTION:

SEE INSTRUCTION MANUAL

FOR CORRECT SETTING.

6 OHMS	4 OHMS
MIN.	MIN.
/ SPEAKER	/ SPEAKER

VOLTAGE SELECTOR

120V

220-230V

MULTI	DIGITAL INPUT
PRE OUT CHANNEL INPUT

IMPEDANCE SELECTOR

SubwooferCenter speaker

18