Onkyo TX-DS787 manual 29

The On-Screen Display (OSD) menu

OSD

Menu

1.Speaker Setup
2.Input Setup	1.Speaker Setup
3.Listening Mode Setup
4.Preference
5.OSD Setup

1.Speaker Config 2.Speaker Distance 3.Level Calibration 4.Bass Peak Level

ENTER Quit:OSD

Main menu

ENTER Quit:OSD

Menu

1-1.Speaker Config

a.Subwoofer :Yes b.Front :Small

c.Center :Small

d.Surr L/R :Small e.Surr Back :Small f.Surr Back Out :1ch

Quit:OSD

Sub menu

Navigating through the OSD menu

The explanations here assume you are using the buttons on the TX-DS787 when entering the OSD menu. However, you can use the buttons on the remote controller as well. In addition to the display of the OSD Menu on your television monitor, the corresponding menu will also be displayed in the front display on the TX-DS787.

The buttons on the remote controller correspond to those on the TX-DS787 as shown below.

1.Press the MENU button.

The main menu screen of the OSD menu appears on your TV monitor.

2.Using the and cursor buttons, select the menu that you want to enter.

3.Press the ENTER button to enter the selected menu.

The screen for that menu appears.

Button on remote controller	Button on TX-DS787
OSD/MENU	MENU
	MENU
(upper edge of	UP
ENTER button)
(lower edge of	DOWN
ENTER button)
	DSP/PRESET
(left edge of	(turn the
	SSC dial
ENTER button)
	to the left)
	PUSH TO ENTER
	DSP/PRESET
(right edge of	(turn the
ENTER button)	SSC dial
	to the right)
	PUSH TO ENTER
	DSP/PRESET
ENTER	(press the
	SSC dial)
	PUSH TO ENTER
	EXIT
EXIT/RETURN	EXIT

4.Using the and cursor buttons, select the sub-menu that you want to enter, and press the ENTER button.

Each sub-menu has different settings that can be changed as

desired, and they are all explained below. To change a setting, first select it using the and cursor buttons, and then change the setting using the and cursor buttons.

5.Press the EXIT button to set the new settings and return to the previous menu screen, and again to return to the main screen.

Note:

Press the MENU button to exit the OSD menu immediately.

If the OSD Menu does not appear

If the monitor is connected to MONITOR OUT (VIDEO) of the TX-DS787, then perform the operations given below and set the OSD output to “Video.” (The initial setting is “S Video.”)

1.Press the MENU button.

“1. Speaker Setup” appears in the front display.

2.Turn the SSC dial to the right to display “5. OSD Setup” and press the SSC dial.

“OSD Config?” appears.

3.Press the SSC dial.

“OSD Out: S Video” appears.

4.Turn the SSC dial to the right to display “OSD Out: Video.”

The OSD output changes to “Video.”

29