Onkyo TX-DS787 40

Input Setup

2-4. Tone Control sub-menu

This sub-menu allows you to increase or decrease the volume for only the low (bass) or high (treble) frequency sounds. This sub- menu does not appear if “Direct” or “THX” are selected as the listening mode.

1.Speaker Setup 2.Input Setup 2.Input Setup

Input:DVD 3.Listening Mode Setup

4.Preference a2.-Audio4.ToneSetupControl

5.OSD Setup b.VideoInput:DVDSetup

c.Listening Mode Preset d.aTone.BassControl : 0dB e.IntelliVolume

f.b12V.TrebleTrigger : 0dB ENTER Quit:OSD

ENTER Quit:OSD

Quit:OSD

a. Bass

Press the cursor button to decrease the bass sounds and press the cursor button to increase the bass sounds. The bass can be

adjusted between -12 and +12 decibels in two steps.

b. Treble

Press the cursor button to decrease the treble sounds and press the cursor button to increase the treble sounds. The treble can be adjusted between -12 and +12 decibels in two steps.

2-5. IntelliVolume sub-menu

When switching input sources, you may find that the output level for different components or input sources connected to the TX- DS787 is different even though the main volume setting is the same. Under normal circumstances, you would then have to change the volume setting each time you change the input source. This IntelliVolume sub-menu allows you to preset a volume level for each input source separately so that when you do switch from one input source to another, the TX-DS787 adjusts the volume accordingly so that the resulting volume stays the same. To set the IntelliVolume, simply select an input source at the front panel, and if that source is quieter than other sources, increase its decibel level with the cursor button, or if it is louder than other sources, decrease its decibel level with the cursor button.

The IntelliVolume can be adjusted between -12 and +12 decibels.

1.Speaker Setup 2.Input Setup 2.Input Setup

Input:DVD 3.Listening Mode Setup

4.Preference 2a-.5Audio.IntelliVolumeSetup

5.OSD Setup b.VideoInput:OPT1Setup

c.Listening Mode Preset da..ToIntelliVolumeControl e.IntelliVolume : 0dB

f.12V Trigger ENTER Quit:OSD

ENTER Quit:OSD

Quit:OSD

2-6. 12V Trigger sub-menu (USA model only)

This sub-menu allows you to make the required settings to turn on the output from the 12V TRIGGER terminal to control another component or device with the TX-DS787 for each input source.

1.Speaker Setup 2.Input Setup 2.Input Setup

Input:DVD 3.Listening Mode Setup

4.Preference 2a-.6Audio.12V TriggerSetup

5.OSD Setup b.VideoInput:DVDSetup

c.Listening Mode Preset da..Tone12V TriggerControl :Off e.IntelliVolume

f.12V Trigger ENTER Quit:OSD

ENTER Quit:OSD

Quit:OSD

a. 12V Trigger

On: Select to activate the connected device when the input source is selected.

Off: Select when no device is connected to the 12V TRIGGER terminal or you do not want the connected device to activate.