Rear panel facilities
ANTENNA
These jacks are for connecting the FM indoor antenna and AM loop antenna that are supplied with the
AMP IN
These jacks are for connecting a graphic equalizer for further control of the audio output.
•When connecting a graphic equalizer, remove the attached jumper plugs and store them carefully so as not to lose them.
•Only remove the jumper plugs when required. After you finish using an AMP IN jack, replace the jumper plug.
PRE OUT
These jacks are for connecting auxiliary power amplifiers.
•When connecting auxiliary power amplifiers, remove the attached jumper plugs and store them carefully so as not to lose them.
•Only remove the jumper plugs when required. After you finish using a PRE OUT jack, replace the jumper plug.
MONITOR OUT
There are 2 monitor outputs and each one includes both composite video and
DIGITAL INPUT/OUTPUT
(coaxial, optical, and
These are the digital audio inputs and outputs. There are 5 digital inputs with coaxial jacks, 3 with optical jacks, and 1
COAXIAL Coaxial cable
•When using the digital inputs and outputs, make sure to also connect the analog connections whenever possible.
•When using one of the optical input or output jacks, remove the protective cap and keep it safely. When the jack is not used, replace the protective cap.
•When using an optical input or output jack, always use an optical fiber cable.
COMPONENT VIDEO INPUT/OUTPUT
If your DVD player or other device has component video connectors, be sure to connect them to these component video connectors on the
Y PB PR RCA type
AC OUTLETS
The
AC 120V 60Hz
SWITCHED
AC OUTLETS TOTAL 120W 1A MAX.
| INPUT 2 |
|
| INPUT 3 |
|
| OUTPUT |
|
Y | P | P | Y | P | P | Y | P | P |
AV RECEIVER
MODEL NO.
L
AC
FRONTINLET
SPEAKERS
R
CAUTION:
SPEAKER IMPEDANCE
OPTICAL Optical fiber cable
Optical digital input terminal
An optical digital input terminal is
CENTER
SPEAKER
Caution
6 OHMS MIN. PER EACH SPEAKER TERMINAL
IR IN
MAIN ZONE 2
AC 120V 60Hz
SWITCHED
AC OUTLETS TOTAL 120W 1A MAX.
U.S. and Canadian
models
equipped with a protection cap. When connecting, remove this cap. When not using, put the cap back on the terminal.
Make sure that the total capacity of the other components connected to this unit does not exceed the capacity that is printed on the rear panel. For the North American model, the capacity is 120 watts.
13