Onkyo TX-DS989 manual 29

The On-Screen Display (OSD) menu

OSD

Menu

1.Speaker Setup
2.Input Setup		1.Speaker Setup
3.Listening Mode Setup
4.Preference
5.Zone2 OSD Setup		1.Speaker Config
6.About			1-1.Speaker Config
		2.Speaker Distance
		3.Level Calibration
Select:	Exit:EXIT	4.Bass Peak Level	a.Subwoofer	:Yes
		5.LFE Level Setup
Enter:ENTER Quit:OSD			b.Front	:Large
Main menu			c.Center	:Large
			d.Surround L/R
Display		Quit:OSD		:Large
			e.Surround Back
		Menu		:Large
				Quit:OSD
			Sub menu

Navigating through the OSD menu

The explanations here assume you are using the buttons on the TX-DS989 when entering the OSD menu. However, you can use the buttons on the remote controller as well.

The buttons on the remote controller correspond to those on the TX-DS989 as shown below.

1.Press the MENU button.

The main menu screen of the OSD menu appears on your TV monitor.

2.Using the and cursor buttons, select the menu that you want to enter.

Button on remote controller	Button on TX-DS989 (under cover)
OSD MENU	MENU
(upper edge of	UP
ENTER button)
(lower edge of	DOWN
ENTER button)
(left edge of	LEFT
ENTER button)
(right edge of	RIGHT
ENTER button)

3.Press the ENTER button to enter the selected menu.

The screen for that menu appears.

4.Using the and cursor buttons, select the sub-menu that you want to enter, and press the ENTER button.

Each sub-menu has different settings that can be changed as

desired, and they are all explained below. To change a setting,

first select it using the and cursor buttons, and then change the setting using the and cursor buttons.

5.Press the EXIT button to set the new settings and return to the previous menu screen, and again to return to the main screen.

Note:

Press the MENU button to exit the OSD menu immediately.

ENTER	ENTER
EXIT RETURN	EXIT

29