Onkyo TX-NR3008 Enter, Mac Address, Dhcp, IP Address, Subnet Mask, Gateway, DNS Server, Proxy URL

2 Use qw/ to select “Hardware Setup”, and then press ENTER.

The “Hardware Setup” menu appears.

7.Hardware Setup

1.Remote ID

2.Multi Zone

3.Tuner

4.HDMI

5.Auto Power Down

6.Network

7.Firmware Update

3 Use qw/ to select “Network”, and then press

ENTER.

The “Network” screen appears.

7-6. Network
MAC Address	xx : xx : xx − yy : yy : yy
DHCP	Enable
IP Address	aaa.bbb.ccc.ddd
Subnet Mask	aaa.bbb.ccc.ddd
Gateway	aaa.bbb.ccc.ddd
DNS Server	aaa.bbb.ccc.ddd
Proxy URL	8080
Proxy Port

4 Use q/wto select the setting, and use e/rto set them.

To enter an IP address, select the setting, and then press ENTER. The arrow can then be used to enter numbers. Press ENTER again to set the number. The settings are explained below.

5 When you’ve finished, press RETURN.

The save confirmation screen appears.

7-6. Network

Save

Cancel

6 Use q/wto select “Save”, and then press ENTER.

When modifying network settings, after modifying it is necessary to execute “Save”.

7 When you’ve finished, press SETUP.

The setup menu closes.

Note

•This procedure can also be performed on the AV receiver by using SETUP, arrows, and ENTER.

■Mac Address

This is the AV receiver’s MAC (Media Access Control) address. This address cannot be changed.

■DHCP

This setting determines whether or not the AV receiver uses DHCP to automatically configure its IP Address, Subnet Mask, Gateway, and DNS Server settings.

`Enable:

DHCP enabled.

`Disable:

DHCP disabled.

If you select “Disable”, you must configure the “IP Address”, “Subnet Mask”, “Gateway”, and “DNS Server” settings yourself.

■IP Address

If you set the “DHCP” setting to “Disable”, you must specify an IP address. Enter a static IP address provided by your ISP.

The IP address must be within the following ranges.

`Class A:

10.0.0.0to 10.255.255.255

`Class B:

172.16.0.0to 172.31.255.255

`Class C:

192.168.0.0 to 192.168.255.255 Most routers use Class C IP addresses.

■Subnet Mask

If you set the “DHCP” setting to “Disable”, you must specify a subnet mask address.

Enter the subnet mask address provided by your ISP (typi- cally: 255.255.255.0).

■Gateway

If you set the “DHCP” setting to “Disable”, you must specify a gateway address.

Enter the gateway address provided by your ISP.

■DNS Server

If you set the “DHCP” setting to “Disable”, you must specify a DNS server.

Enter the DNS server addresses provided by your ISP.

■Proxy URL

To use a Web proxy, enter its URL here.

■Proxy Port

If you’re using a Web proxy, enter a proxy port number here.

■Control

This setting enables or disables control over the network.

`Enable:

Control over the network enabled.

`Disable:

Control over the network disabled.

Note

•When set to “Enable”, power consumption on standby mode increases.

■Port Number

This is the network port used for control over the network.

Note

• Set the port number between from “49152” to “65535”.

En

77