Onkyo TX-NR636 manual Turning the power on, Making the Initial Setup with the Setup Wizard

Step 2: Setting Up

Important: When the unit is turned on for the first time, the setup wizard of the section 2 will automatically be launched. If you use the setup wizard to make the initial setup, connect a TV to the HDMI OUT MAIN jack of the unit via HDMI connection.

1 Turning the power on

Connect the power cord to the outlet. Press zON/ STANDBY on the main unit or zRECEIVER on the remote controller to turn the unit on or to standby mode.

Initial Setup

Language Select

English

Deutsch

Français

Español

Italiano

Nederlands

Svenska

HOME Exit

¼¼Taiwanese models include a removable power cord. Connect the power cord to AC INLET of the unit and then connect to the outlet. Always disconnect the outlet side first when disconnecting the power cord. When the unit is turned on, a large instantaneous current may flow affecting functionality of the computer and other devices. It is recommended to use a separate outlet from that for the computer or such other sensitive devices.

Firmware update notification: If the unit is connected via LAN and there is firmware update available, the "Firmware Update Available" message will appear. To execute updating, select "Update Now" with the cursor buttons of the remote controller and press ENTER. When "Completed!" appears, press zON/STANDBY on the main unit to turn the unit into standby mode. Then updating will be completed.

2 Making the Initial Setup with the Setup Wizard

Read before starting the procedure: Set up by answering the guidance displayed on the TV screen. Select the item with the cursor buttons of the remote controller and press ENTER to confirm your selection. To return to the previous screen, press RETURN.

•If you terminate the procedure on the way or change the setting made in the initial setup and want to call up the setup wizard again, press RCV and then HOME on the remote controller, select "Setup" - "7.Hardware Setup" - "Initial Setup", and press ENTER.

Select the language first. In the next screen, the summary of the setup wizard as below will be displayed. Select "Yes" in this screen and press ENTER on the remote controller.

Initial Setup

Welcome to initial setup. Have you connected all the speakers and devices? Before starting, please connect speakers and sources.

Now, would you like to start initial setup? 1st Step : AccuEQ Room Calibration 2nd Step : Source Connection

3rd Step : Remote Mode Setup

4th Step : Network Connection

Yes

No

HOME Exit

1st Step : AccuEQ Room Calibration

2nd Step : Source Connection

3rd Step : Remote Mode Setup

4th Step : Network Connection

1st Step : AccuEQ Room Calibration

The test tone coming from each speaker will be measured to enable setting of the number of speakers, volume level, each speaker's optimum crossover frequencies, and distance from the primary listening position, and also enable correction of distortion caused by the room acoustic environment.

Initial Setup

AccuEQ Room Calibration

This step you can automatically calibrate your room to get correct surround sound. Would you like to cailbrate your room now or later?

Do it Now

Do it Later

HOME Exit

1.Place the speaker setup microphone.

When the start screen above is displayed, before starting the procedure, place the supplied speaker setup microphone at the measurement position  by referring to the figure below.

Listening area	Measurement position
	with microphone

¼¼Correct measurement will not be possible if the microphone is held by

hand. Measurement is not possible if headphones are being used. ¼¼The subwoofer sound may not be detected since it is extremely low

frequencies. Raise the subwoofer volume to around the half of its maximum volume and make its frequency to the maximum level.

¼¼A loud test tone will be heard during measurement. Measurement may be interrupted if there is ambient noise or radio frequency interference. Close the window and turn off the home appliance and fluorescent light.

7